Jump to content
SAU Community

Recommended Posts

Hello,

I was wondering if anyone can help me with some wisdom on how to remove the drivers door panel of my R33.

So far I have removed all screws from the bottom, and unclipped all of the gromits, but I think there is still another screw somewhere behind the window switch control panel.

I can remove the plastic finger handle from the door, but am unsure how to take the plastic window switch control panel off - I don't want to force it in case I break the bastard!

Does anyone have any tips on how to get this panel off?

Thanx in advance...

Link to comment
https://www.sau.com.au/forums/topic/21019-removing-r33-drivers-door-panel/
Share on other sites

have u poped out the round plastic cover inside the plastic thing that u put ur hands in to close the door....there is a screw there. other than that it should be ready to pull of. it is abit hard to get off as the top part of the door trim wedges up on the part where the mirror is but it does come off. as for the switch control pannel theres two clips one at the end where the buttons are and one in the middle...this is where u should hold to pop it out so u dont crack anything.....there are no other screws so if u take off the door trim this control cover will come with it......have fun!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...