Jump to content
SAU Community

Recommended Posts

good thing you are so good looking cause ya can't drive for sh1t! :(

hehe, nice work mate, 11.8 for the little silvia is fairly hauling. I love the old valiants though. we need some pics!

good thing you are so good looking cause ya can't drive for sh1t! :(

hehe, nice work mate, 11.8 for the little silvia is fairly hauling. I love the old valiants though. we need some pics!

post-26741-1205731797_thumb.jpg

Here ya go Baron, pic of the Val.

I agree Paul.. your too fast now yeah?

over a second too fast now...9.9's now and about 2-3 tenths left in it at current power.

Will be racing again May 18th at Compak Attak...would love some support from you SAU guys again.

GTR 700 will be racing as well...aiming for a 7 sec. pass.

over a second too fast now...9.9's now and about 2-3 tenths left in it at current power.

Will be racing again May 18th at Compak Attak...would love some support from you SAU guys again.

GTR 700 will be racing as well...aiming for a 7 sec. pass.

pfft, girl... all that would have happened is they would have asked you kindly to please leave the premises...

there's plenty of other dragstrips to go to :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...