Jump to content
SAU Community

Recommended Posts

Hey guys!!!

Merli's probably busy ordering more parts for his new toy, so ill do the details this time

Food: Pizza

Date: 10/04/2008

Time: 730pm till whenever

Booze: Bottleshop 2 shops away, BYO is fine

Cost guide: Depends how much you eat of course, Large pizza is $18

Address: Italian Pizza Factory, Corner Mitchell Rd and Huntley St Alexandria 2015 (02)9516 3040

Map: (attached below)

Parking: Heaps of street parking very close/right outside

aprildinnermap.jpg

Who's going?

N1GTR

NYTSKY

lingeringsoul

adgey

evil_weevil + his boss

D_I_F

frozenwaffles

Liz

intune

Abo Bob + his boss

Maybes:

Merli

Duncan

  • Replies 93
  • Created
  • Last Reply

Top Posters In This Topic

St Peters, its a couple of mins to walk.

Exit the station on the prices hwy side, cross the lights, start walking down the street that has the park alongside. Take first left, the bottle shop is right there, then the pizza shop is just next door :P




  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...