Jump to content
SAU Community

Recommended Posts

gday.

im selling a GT30R top mount setup. details are

GT30R .63 rear housing - turbo is in good condition, seen around 50 to 60 thou ks

Mild steel manifold - 38mm runners

Tial copy external gate

Dump pipe

external gate piping and front pipe all to suit.

so basicly all your gonna need is a intake pipe from your afm to the turbo and oil and water lines to suit the turbo.

SOLDb]

ill get pics up in the next few days, at the moment i cant find any on my computer.

cheers

edit:- sold

Link to comment
https://www.sau.com.au/forums/topic/213561-gt30r-kit-to-suit-r33-sold/
Share on other sites

i cant give you a torque figure but suffice to say there was plenty of it. last dyno it pulled around 250rwkw on standard internals + or - around 10kw for different dynos.

i know the last time i went to a track day i was runnin outta grip at the end of my last session and started puttin it sideways through corners and was easily smoking the tyres,

depending on whether my shares keep going back up, might give you a call late next week, if it's still for sale.

when did this setup hit boost.

looking for something responsive. peak power is not too important.

to me this turbo was a very responsive turbo.

due to the smaller exhaust housing it was quite easy for the rb25 to spool it.

iirc i usually had full boost around 2.5k - 3krpm

its been a long time since i drove it so i cant remember, all i can tell you is that its a very good match up for a rb25 engine

I would love it, but the budget just can't stretch that far at the moment.

going in on wed for a new clutch and boost controller, and then probably fitting a wolf 3d a week later.

depending on how quickly i bounce back from that, you will hopefully be hearing from me



  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...