Jump to content
SAU Community

12.1s With 205rwkw

gt-ahhh!

By gt-ahhh!,
in General Automotive Discussion

 Share

Recommended Posts

gt-ahhh! Proficient

gt-ahhh!

Posted
Posted

so this guy i know is buying an sti wrx. the previous owner is claiming a wsid quarter mile of 12.1s with only 205kw at the wheels.

i call bullshit. how can that be possible? i reckon youd need the best part of 300 to get a gtr down the other end in 12.1.

thoughts?

Link to comment
https://www.sau.com.au/forums/topic/215631-121s-with-205rwkw/
Share on other sites
Bumblebee Experienced

Bumblebee

Posted
Posted (edited)

umm try 11.7 for 300awkw gtr... :)

Edit: just realised what i wrote.. 11.7??? for 300awkw?? oh god.. the stock R35 with less power does it faster.. all because of its super gearbox.. :D

Edited by Bumblebee
R31Nismoid Grand Master

R31Nismoid

Posted
Posted
so this guy i know is buying an sti wrx. the previous owner is claiming a wsid quarter mile of 12.1s with only 205kw at the wheels.

i call bullshit. how can that be possible? i reckon youd need the best part of 300 to get a gtr down the other end in 12.1.

thoughts?

300? I reckon you need to research :D

A GTR can get into the mid 11's with stock turbos if driven hard. So around 250awkw is all.

gt-ahhh! Proficient

gt-ahhh!

Posted
  • Author
Posted
No, 250rwkw if that.

Its all about tyres and practice mate.

I went 12.9 with 210rwkw back when i was racing (1400kg), and that was 225 street tyres, semis/slicks would be mid-low 12 no problem.

phwoar. i reckon ive got about 250, so we might give it a good shake! smash all the hsvs there running 14s.

one more thing, since you appear to be a source of much knowledge. ill chuck v power racing in, 100ron. is it worth getting booster? much more powah? bad for engine etc?

some_cs_student Veteran

some_cs_student

Posted
Posted
No point without tuning for the fuel really.

But wouldn't it be a good idea to prevent pinging? I know its a good idea on the track but since the drag is soooo much shorter is it even worth going a higher octane fuel?

R338OY Veteran

R338OY

Posted
Posted
i reckon youd need the best part of 300 to get a gtr down the other end in 12.1.

My mate does 12.2 in a 280awkw GTR, with 4WD problems. He could do even better.

ill chuck v power racing in, 100ron. is it worth getting booster? much more powah? bad for engine etc?

Isn't it 5-10% ethanol? Not recommend for your car, can damage the injectors. A one off? Then i wouldn't worry.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Duncan
      V37 Radiator removal

      By Duncan · Posted

      So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You don't need to drain the intake heat exchanger to remove the radiator but depending on your plans you may need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • EndZee
      R33 Gts/-t Abs Module Wiring Schematic (not Gt-r)

      By EndZee · Posted

      Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • GTSBoy
      Boost cut after swap(RB25DET NEO) R34

      By GTSBoy · Posted

      Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
×
×
  • Create New...