Jump to content
SAU Community

Recommended Posts

Guys I need some sympathy. I had to go to the dentist today so I left work early. Leaving the car park at work I noticed that the tyre spun really easily. That's odd I thought. Luckily it was a short drive to the dentist.

So I checked the tyres thinking maybe I rolled through something. Yes one had an oily residue. But then I saw the puddle forming under the front spoiler! :wub: Oil was running out from the car and there were two lines into the car spot! I immediately shut down the turbo timer while looking at the oil pressure gauge. At least it was still getting pressure.

So then I had to sit and get my teeth cleaned all the time thinking - my car! Oh son of rajab what to do... Should I bypass the remote oil cooler and put the filter back on the block to get it home? How am I going to work in the car park? My wife being the rational one convinced me to get it towed home on a flat bed. Luckily it wasn't too far either.

I hate the feeling of the car on the tow truck being paraded through rush hour. How humiliating!

Now I have work functions going on until Sunday so won't have time to look at the car. ARGH! ;)

Well, on the upside at least the car never lost oil pressure and I had just changed the oil last weekend so it was fully topped up.

Link to comment
https://www.sau.com.au/forums/topic/219040-oil-black-gold/
Share on other sites

Won't have a chance to look at it until Sunday. I'm betting it is a fitting as the dribble is coming from two spots so it must be running down the line. The pressure hit 6.5 bar (cold, no I wasn't rev'n it) at max so I doubt it could have split a line.

I'll post the results when I get under it this weekend.

Link to comment
https://www.sau.com.au/forums/topic/219040-oil-black-gold/#findComment-3866349
Share on other sites

:happy::wub: Checked the problem and It's only a pinhole in the oil line! :) :)

I'm so relieved that it isn't something more major. You know how your mind plays with you.. suddenly you realise that not only are the oil lines in front but so is the oil pump. What if that went out?

What does seem strange is that the pinhole is in the middle of the line, not an end nor is it at the tightest point. It is exposed as there isn't a gravel shield under my car. But this is stainless braided shielded lines with a plastic liner. How does something puncture that for a pinhole? And these are less than 6 months old too. I bought the kit from UAS in December and installed in January.

I'm thinking I'm going to replace all the lines just in case. I don't want this happening sometime/somewhere that I don't notice until the oil pressure goes to 0 then bye bye motor.

Anyways, happy story for now.

Thanks folks!

Link to comment
https://www.sau.com.au/forums/topic/219040-oil-black-gold/#findComment-3873655
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...