Jump to content
SAU Community

Recommended Posts

ok, i searched for some other threads though i thought id post another since my symptoms are a little different. it seems when i get up near 90kmh or faster, theres a shuddering in the steering wheel. it seems to be temperature related too? if you get up to 90kmh within 15 mins or so of starting the car from cold, the shudder is there, but once the car has been warmed up for a while, it goes away. since the car will be going in for a big service soon i figure i should compile a list of things to check through

dont worry sounds the same as mine

all i need is a wheel balance and alignments those are what i have been told it is (professional mechanic guy for rims and alignments and balancing drove it and its been conformed)

so id say 99.9% sure :D

I will be interested to see how you go with this as sounds similar to a problem I have had for the last 3 years - tried wheel balancing and alignments (at both tyre places and professional suspension places) plus put in a castor kit (made a difference)

Is worse when colder and seems to disappear after a while

yeh it seems odd, as all the tyres were replaced only 3 months ago, and barely 2000kms at that. the only other thought is something to do with the drivetrain...it definitely goes away once the car is warmed up substantially, so if it was a tyre balancing issue, wouldnt it always be there?

are there any possible issues with bearings, diffs or attessa system warming up?

its not wheel alignment or balancing. I had the same issue. It is the power steering pump and fluid. Seems to be fine once the car has heated up. Check your fluid levels, give it a good flush with some new fluid and take it easy until the car has warmed up.

Just read the stroy in HPI of gtr brake upgrade this is the explanation it gives of brake shudder

Qoute"In a nutshell if your getting feedback through the steering wheel and suspension when you brake at certain speeds and pressures,then you are experiancing what is known as brake shudder,This feedback can range from a faint vibration that is barely noticeable,to a series of shakes that are so bad they feel violent enough to almost rip the wheel from your hands. It doesnt matter if your on the track or the street,because it is caused by an uneven build up of pad materieal on the surface of the rotors. It is agrrravated by the high temps of the track and by the switching back and forth between two incompatible friction materials. It should also be pointed out that the shudder is the result of a thickness variation in pad build up on the rotor surface and not the popular myth that it is caused by warped rotors."end quote

Hope this helps somewhat there is also a very good guide to bedding in brakes and pads but to much for me to re-type here i suggest everyone grabs a copy and has a read for themselves some very good info in there. The article also gives Hawk pads the big thumbs up for pads i read somewhere else on these forums that they make str8 swap pads for stageas so this may be of note to those needing to upgrade soon.

Hope this helps somewhat there is also a very good guide to bedding in brakes and pads but to much for me to re-type here i suggest everyone grabs a copy and has a read for themselves some very good info in there. The article also gives Hawk pads the big thumbs up for pads i read somewhere else on these forums that they make str8 swap pads for stageas so this may be of note to those needing to upgrade soon.

LOL

just be aware that there are a couple of skyline owners (and a 350Z owner) that are too paranoid to brake near a cop car, using those Hawk pads, as they increase brake noise a LOT.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi all, I’ve just finished fitting the timing belt on my RB25, following the standard procedure: rotate the crank twice, release the tensioner, then tighten it down. The belt feels tight, and you can see that clearly in the picture below I’ve heard some people say it’s actually better for the belt to be slightly loose rather than too tight, as excessive tension can lead to snapping. So that’s in the back of my mind. What I’m seeing is this:  • At idle, the belt looks fine.  • But when cranking and especially when revving (around 3–4,000 RPM), there’s a momentary flap/flex or flicker in the belt, which I’ve tried to capture in the video. So my question is — based on what you see, is this slight belt movement something you’d consider normal, or am I just being OCD? Could this amount of movement cause sync issues? Or is it just a harmless bit of flex under load?   from what I know belt flap and flex is expected when crank spins up and pull cam with it Would appreciate any thoughts or similar experiences.     IMG_7656.mov IMG_7657.mov
    • I've replaced the front brakes of my NA to 324 brembos and 350z calipers: i'm going for 225/40-18 up front and 245/35-18 in the back. I have Rays 7.5*19 ET35(225/35) in the front with 5mm spacers otherwise the calipers "lock up/ won't rotate". When i use the calculator i come up with 8*18 ET30 for 225/40...... but not sure i get problems with the calipers. Anyone riding around with 18 inch. that can confirm "that it'll fit"? In the back it's 7.5*9 ET30 (245/30) with the 5mm spacers, but there is no problem with the standard small brakes, so i want to take 8.5*18 ET25 (245/35).
    • Lol.. but then.. always come back to a JDM..
    • Glad to hear. If possible, get your tuner to check air's to make sure everything is still where it should be.
    • The problem with FB/Insta/Reddit etc comments relating to cars is simple. You get to ask a question once, and get one round of replies. For things that can actually be answered in a few lines of text, once, it's fine. After 6 hours, your original question is lost to the void. There are no follow ups, additional questions, anything. No project car is ever such a simple list of questions to ask. You need discussion.
×
×
  • Create New...