Jump to content
SAU Community

Recommended Posts

just got my new setup and im now running 251rwk in my r33 gtst

what 1/4 mile times should i expect?

im running my 18inch rubber this week which are maxxis maz1's 265/35/18's. fortnight after i will run full slicks to see its true potential .

traction is managable from 2nd gear on :P

Link to comment
https://www.sau.com.au/forums/topic/222684-14-mile-times-with-250-rwk-r33-gtst/
Share on other sites

  • 2 weeks later...

ok looks like clear skys this friday.

dont know whether to run full slicks or street tyres.

will the exedy clutches hold up with hard launches on slicks? am i prone to break something with slicks cause ive never raced with them before?

thoughts

ok looks like clear skys this friday.

dont know whether to run full slicks or street tyres.

will the exedy clutches hold up with hard launches on slicks? am i prone to break something with slicks cause ive never raced with them before?

thoughts

In order starting with the weather and working down:

1/ Good shit!!

2/ Run streeters, you know you want to.

3/ No.

4/ Yes.

and

Thoughts:

Don't run crossply rear tyres with radial fronts. It gets very ugly, very fast. If you run quicker than 12.500 like that you'll get a boot in the arse but it can be unsafe long before that point.

went to calder tonight and had problems with the boost falling off resulting in a 14.3 @ 93 mph.

2nd run i turned the boost down to 14.5 psi down from 16.5 and ran a 13.3 @ 112mph, 60ft was 2.31. and my gear changes were slower than normal.

need to get the car fixed so i can turn the boost back up and give it another shot

went to calder tonight and had problems with the boost falling off resulting in a 14.3 @ 93 mph.

2nd run i turned the boost down to 14.5 psi down from 16.5 and ran a 13.3 @ 112mph, 60ft was 2.31. and my gear changes were slower than normal.

need to get the car fixed so i can turn the boost back up and give it another shot

Easy 12's mate..

Trap speed indicate deep into the 12's ... I ran a 12.4 with only 108mph(but then again it's a GTR), 1.8sec 60ft

Cut that 60ft down and you will be in the 12's guarenteed!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...