Jump to content
SAU Community

Recommended Posts

If anyone can help would be appreciated

Doesnt always do it but will idle high when decelerating and when take out of gear sits on around 1200-1500 revs and wont go down unless i hit accelerator.

Friend mentioned AAC but cant find thread on here on how to do it, could it be caused by anything else?

I have aftermarket radiator bought from here, MSpec bit larger

Splitfire coilpacks

NGK platinum sparkplugs

Oil cooler

POD

Was happening even before i installed any of these on my car

Injectors need to be changed as ticking noise coming from them

Thanks for any help

Link to comment
https://www.sau.com.au/forums/topic/228103-idling-high-mostly-on-decelaration/
Share on other sites

  • 1 year later...

OK well idle thing has been happening still, now on deceleration i can hear it spluttering , and can see the revs not dropping fast enough like it does when its running ok.

Have done an oil flush, could it be anything to do with the exhaust, maybe a new muffler needed?

Cleaned AAC valve and didn't make much difference at all.

Cleaned AFM, was very dirty but didn't change anything.

Anyone had this problem and can help?

When i tap the accelerator to lower the revs they don't always drop....

No definately not auto :thumbsup:

How much is a new O2 sensor??

Incase it is that, I want it fixed asap as is driving me nuts

Don't know about being a stuck throttle body as hitting the accelerator doesn't do much to it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...