Jump to content
SAU Community

Recommended Posts

I really want three new guages - boost in PSI, oil temp and exhaust gas temp.

Boost and temp will be cheap Splitfires. I think I'll match it with an oil or water temp guage so there's a neat 3 guages in the central console.

The EGT however will end up being most likely an Autometer or Apex EL on the A-pillar.

Seems ok? I have doubts about the A-pillar as I don't want to be defectable.

T.

Link to comment
https://www.sau.com.au/forums/topic/22870-what-guages-are-important-to-you/
Share on other sites

Originally posted by Shane

It may only be heresay, but isn't an A-Pillar legal as long as its below the top of steering wheel? That's where I just put mine anyway *shrugs*

Anything u mount on the dash/a pillar has to be lower than the highest point on your dash. Tried to mount a 5' tacho legally in my old car, didnt work, but close :(

I have EL boost on the A-pillar and Water Temp, Oil Temp and Fuel Pressure Defi's on the console. Also AVCR and RSM (mmm - Gs) are on the dash.

I look at the AVCR and water-temp most of the time. I use the speed readout on the RSM for highway driving (it flashes at 103km/h).

G's are good for passengers :)

I've never understood why people want a boost gauge. I set my boost on the dyno, and I leave it. Most boost controllers have a digital boost readout anyway.

People say "What if your boost spikes? or if you overboost to 1.5 bar? Don't you want to know about it?"

I say in reply: "You should set you boost up on a dyno and iron out all the spikes there. Has your boost controller ever "broken" and you've overboosted over what you set your boost controller at? I haven't."

Anyway. If I were to have any gauges it would be:

Water Temp

Oil Temp

in WA u can get permits for a pillar mounted gauges, aslong as they dont obstruct the vision. I had permit for Oil pressure gauge and monser tacho(albiet that was a wank permit haha). But we also have permit for the Sti with boost and oil pressure.

small gauges are fine. In words of guy at pits, cop was an idiot for point out the gauges as a defect.

"Boost and temp will be cheap Splitfires"

Don't get anything cheap - unless you just want them for the 'looks'. Otherwise you are defeating the purpose of trying to accurately monitor what's going on with your car.

As for "why have a boost gauge?" - if I, for example, blew a hose, the boost gauge would instantly tell me that. If there is a problem with the car, and it is boost related, the gauge will instantly tell me that. If my car starts to spike (for whatever reason), I can see it instantly and shut her down.

And my other 2c: buy defi

Originally posted by DaiOni

As for "why have a boost gauge?" - if I, for example, blew a hose, the boost gauge would instantly tell me that.  If there is a problem with the car, and it is boost related, the gauge will instantly tell me that.  If my car starts to spike (for whatever reason), I can see it instantly and shut her down.

What hose could you blow that would affect boost? Intercooler plumbing? Silicon hoses on the intake plumbing? They'd all REDUCE boost, so you don't have to worry. The only thing would be the hose to your wastegate actuator.... How many people do you know who's wastegate vacuum hose has fallen off? None?

You'd notice any increased boost, or an "unlimited boost" effect from the wastegate problems before you'd look at the boost gauge anyway, true?

What other reasons are there that the boost would suddenly decide to spike? If you have a decent boost controller, I can't see it EVER changing it's settings, unless you've stuffed around with it.

The only time I can ever see a boost gauge coming in handy is when setting up the car's boost levels and gain/balance.

I think Summoner gave the truth :) Everyone loves it because it's the most active gauge. The others (water temp, oil temp, EGT, whatever) don't move anywhere near as much, and doesn't have the "COOL" factor :D

Yes, I too like boost gauges cos they move :) Everyone wants to see something working and it's actually doing something. I think boost gauges are important (to me anyway) because I have the Profec B boost controller (no boost display). I have low and high boost and sometimes I like to see what the max boost is set at. I sometimes adjust the low and high settings too, so I don't want to set it too high and blow something. I think boost gauges are useful.

"What hose could you blow that would affect boost? Intercooler plumbing? Silicon hoses on the intake plumbing? They'd all REDUCE boost, so you don't have to worry"

I'm talking about the sequential setup of a late model rx7, which is my case. Your original post didn't specify 'skylines' which is why I responded as such. On my car, the boost gauge is a neccesity - which is why 'people' sometimes need them. However, I can't imagine why having a boost gauge would be a bad thing on any turbocharged car.

The defi gauges have a memory function - so you can record the boost gauge (for around 3 minutes) and play it back. This is a great little diagnostic tool - which has plenty of uses.

You are damn lucky to get DEFI link gauges! :) They are quite pricey aren't they? Is it true that when you start up the car the gauges calibrate and the pointer on the gauges moves right through the range? Example: If you have a boost gauge from 0bar to 2bar, when you start the car the "pointer" moves from 0 bar to 2 bar and then moves back down to 0bar? Nice :D

my cefiro has a tomei boost gauge and i have hardly looked at it. Mind u at present my EBC isnt wired up properly(so it looks), so i was curious as to what boost it was running, seems to be about 0.7bar or so.. Short of that i doubt i'll actually be looking at it :)

yeah, the gauge cycles on start up, beeps, has a whizz-bang closing down 'ceremony' etc

I got them because they are made by a company that specialises in gauges - not a company that makes all sorts of shit, and does gauges on the side.

I've shopped around and they are by far the best quality on the market.

And yeah, expensive, but not as bad from within japan (cost me about 34,000 yen for the control unit, boost gauge and holder)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Welcome to my 2004 Toyota Mark ii IR-V Fortuna (series 2) With a 1JZ-GTE powerplant under the bonnet (hood) it'll give me plenty of scope for power upgrades. For those who aren't familiar with imports, the 1JZ-GTE is a 2.5L 6 cylinder VVTi engine with a single turbocharger. This has the factory R154 5 speed gearbox, along with a aftermarket 2 way LSD differential (brand unknown). Under the arches are a set of CST Zero 1 alloys, 18x9 +30 225/40 up front and 18x9.5 +15 265/35 on the rear. The car was quite low in Japan and there's evidence of the wheels catching the rolled arches/fenders. The tyre's aren't great so I'm in two minds whether to replace both or just the tyres and put up with the wider wheels on the rear. The car still uses stock brakes with the addition of some braided hoses. The exterior is stock with the exception of a BN Sports front bumper and a replacement Fortuna grill  Moving to the interior, the steering wheel has been replaced with a dished MOMO steering wheel (which will get swapped for my Momo Tuner for the time being) Defi Link Gauges are mounted above the climate controls and on the A pillar, the Oil Temp,Oil Pressure,Water Temp and Boost gauges should help with spirited and track driving  The stock seats have been replaced with some retrimmed Recaro bucket seats. Being a larger build these are a little snug, unfortunately the orange isn't for me so I'll look into replacing these down the line. Other modifications include a twin plate clutch, Blitz intercooler, Evolve alloy radiator, a stainless exhaust with decat, HKS EVC-S boost controller and coil overs
    • Apologies for the long read My R34 GTT was up for sale at the beginning of spring due to a few repairs creeping up. The strut tops needed replacing, roof and bonnet (hood) painting (yay for 3 stage pearl) and the underside stripped and treated. I sold the car which allowed me to be in a much better place financially. Leading up to the sale I was already thinking about the replacement. In an ideal world it needed to be a good all-rounder. Something I can mess around with, modify, do track days, do the school run, go on long drives etc.  Options included but not limited to... Laurel C35, Evo 8/9, Civic FD2, Impreza Hawkeye, Aristo and even an Audi S4 Avant (I've already got the Mazda 6 wagon). But there was always one car at the top of the list The Toyota Mark ii JZX110 I found an advert on a Facebook group for an example in Japan, from a seller called Jon at Rising Sun Exports. A few messages back and forth and Jon calls me from Yokohama one morning (or afternoon in his case). He briefly explained the import process, the costs involved and a repeat of the advert. After much deliberation, the price was agreed and the sale was locked in. I've never imported a vehicle so I jumped into the unknown head first. The money transfer was completed through wise.com (fees apply), very easy to use and the money was with him within a day or two.  The car suspension was raised for the vessel and the car dropped off at the port. It was 7 weeks later when the bill of lading was received and the freight invoice sent to me, followed by the export certificate a couple of days after (both digital copies) In the mean time the port had been in contact. I needed an agent to deal with the NOVA (notification of vehicle arrival) along with the tax/duty invoice, this was £75.00. The port also had a fee of £100, I'm guessing to cover the cost of the 10 day 'free storage' and for moving the car off the boat etc. They need a copy of the vehicle invoice, freight invoice and export certificate to allow the vehicle to pass through customs. The vessel arrived on Tuesday 5th August, the tax/duty invoice was generated and sent over. This is generally tax 20% and duty 10% of the vehicle value. Although the invoice came in at a higher amount than I had calculated. Once HMRC had received the payment the vehicle could be released from customs. I thought once the tax/duty was paid you could collect at any point, that's not the case. Your agent will need to book a collection slot, I requested Thursday 7th which was accepted, with a 9:00am slot allocated. It was a 5:00am start from Norfolk heading to Southampton. We eventually found the compound, upon presenting the bill of lading and some ID they released the car (they drove it out of the compound to the front ready for us to load up). The email from the port stated each slot had a 10 minute window, which seemed abit farfetched but the staff said it's not a strict rule. We were there for approx. 30-40 mins in total. A week prior to collecting I contacted my garage and explained the situation, I was able to get an inspection slot that afternoon. For the registration, DVLA require the car to be insured, for this I used a company called Adrian Flux who can insure the vehicle using the VIN number. 
    • Hey guys, looking for these side skirts if anyone can help me out. 
    • Wife and I are still looking for a new home. One condition was a large enough garage for a full-size lift in one bay. Now if only we could find something... We've been looking for almost a year now.
    • Thanks everyone for the ideas! Sadly, ramps are a no go for me. With young kids at home, I do most of my work late at night while they're sleeping. Starting the car multiple times wouldn't be a great idea.  I'll go see one of those new long reach low profile jacks and take a couple measurements to see if they will fit.   
×
×
  • Create New...