Jump to content
SAU Community

Recommended Posts

i'm planning on running 20psi of boost on a rb25det. will the coil take this and what heat range plugs do i need all mods are listed below

Built motor pistons bored to 40 thow. rods nismo oil pump hks head gasket, Race bearings. Main studs and head studs. stock valve train springs,cams etc. stock head.

HKS Gt 3037pro s turbo kit. from japan

HKS twin plate clutch

Power fc with hand controller

World Electornics Boost controller tbc-1 (best money can buy)

Full exhaust NO CAT ( 5 zigen)

Front mount intercooler

Z32 afm (30p00)

100mm intake manifold and T body.

Sard 800cc injectors and rail

Sard in tank 280 lph fuel pump

HKS M45 spark plugs

BF goodrich R1 tyres (Drag)

After market air filter

Ksport coil overs

you need to change your coils for that setup if ur planning to run 20psi.

stock coils uaually crap themselves at 240-250rwk, but some have seen higher figures. Youv'e spent all that money, spend a few hundred more on splitfires and do it right :(

Edited by R33GOD

Mate can you hold off for a couple of days until search works?

All these questions your asking have been covered time and time again... and it'll also stop ill informed responses like the above :(

Because i can tell you now stock coils can do over 370rwkw if in good order, because thats how much power i made on em.

And plenty of people have made more. LOTS more. :(

Guest
This topic is now closed to further replies.


×
×
  • Create New...