Jump to content
SAU Community

Recommended Posts

Is your rear muffler straight thru? I have two mufflers - rear one has an S bend in it to help keep down noise, but have set it up so I can take off the rear one at track for less back pressure. If both are straight thru, prolly not much power advantage removing either, (but will sound heaps good) - that is if mid one is like a hot dog, apparently, if it's really big, turbulence may be removed if you take if off and there will be more power there.

yer the rear is a straight thru, i went and got a quote today on how much it would cost to replace it with a 3'' pipe and was 100 bucks, so ill most likely go thru with it, so when i take it off Zman ill let u know, not sure how much it would be for u to install it on to an existing exhaust, probs round the same as for me replacing it with a pipe...

cheers...ben.

my old system used to have a center muffler and a rear muffler, first i took of the center one cause it wasnt loud enough, that made a difference, but not enough for passangers to even notice it...

finnally i pulled of the rear muffler and replaced it with a smalish 3 inch cannon muffler, with very little baffling material (whatever its called).

Its definatly alot louder, but the problem with skylines (moreso ones with stock turbos), is that they are impossible to make loud, i got the dude at the exhaust shop to start it up with the system off and it still wasn't all that loud...

improvment in power is very minimal, maby a couple of kws?, but more than likely, you wont notice it.

I got mine done aswell, and it cost me $40 as well...$100 is a complete rip off!!!

Mine sounds sweet, a little droney between 2200rpm and about 2500 rpm, but nothing I can't deal with!

The RB series engines sound great, so in my books the louder the better. Sounds gold on full noise whilst drifting with the BOV going off all over the place.

I had the same dilemma a while ago - I had a 3" dump, 3" cat, and two straight-through 3" mufflers. I had a shop remove my centre muffler and replace it with a flaged piece of 3" pipe. Also had them make a dropped pipe, which comes out under the passenger seat and eliminates the cat too, for drags etc.

Anyway, after removing the centre muffler, my car was certainly louder and had a deeper note, but doesn't drone and has quite a nice note. With the dropped pipe on, it's not "that" loud at idle, but you can hear the turbo spool from about 1200rpm, and it sounds like a Nascar when the revs build up around 5k :P But yeah, whether it's too loud or not will depend on the muffling qualities of your remaining muffler. Mine seems to have been perfect, yours might make it too loud or too quiet. Just try it and see. Don't expect a massive power difference though.

  • 1 month later...

Interesting... I too have the 2 mufflers. My exhaust consists of:

3" Custom front/dump pipe -> 3" Cat -> 3" Nismo exhaust with a middle and rear muffler -> 4" Nismo Tip.

I'm thinking of getting this middle muffler cut out and replaced with just a 3" straight through pipe (or possibly getting it done so that i can swap between a muffler or straight through pipe, daily driving vs track/drag).

So about $40 and 30mins and it should be done eh?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...