Jump to content
SAU Community

Recommended Posts

rebadge would be my pick. there are a LOT of G35s running around. I have a black '06 downstairs now :banana: that is done in that fashion.

(why must nissan make 10 different versions of the same car!!! )

I really don't like debadged V35's. To me it kinda takes away a little of the "classiness" of the car.

I also think that the Nissan badging, especially the "350GT" give the car presence.

And I'm not a fan of the Infiniti badging at all. Would take 350GT on my car over G35 any day of the week!

Was gonna say, that's my 2c, but there's a least 10c worth of opinion there :-)

Okay Guys and Gals

I removed the Skyline badges and will try this for a while. I can always remove more later if I want. ;)

First of all I used Colgate Dental floss (the plastic Lid was perfect for scraping the goo after the badges came off)

Then I used Polyglaze bug and tar removed. 3 minutes and two applications later (minimal rubbing) and the goo was all gone :D

gallery_55491_2832_17808.jpg

Closer Peek

gallery_55491_2832_70668.jpg

And last of all, always have a helper

gallery_55491_2832_67754.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...