Jump to content
SAU Community

Eastern Creek Track Day: Friday 31st October


Recommended Posts

  • Replies 80
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Nah man - It sux to be me.....

The S12 PIG is on to it's 2nd rego whilst being in the shop - Shocking......

It's not the shop's fault though - I keep getting them to do stuff to it.

I think they want it out of there as much as I do.....

I hate missing drive days - already lost so much $$ putting down $$ and not getting out there ... bugger

Poor me !

Hmmmm interesting...

Add me to the Bummed Out "Why is my car in pieces instead of doing laps at EC and Oran?" Crew.

I *may* get out there for a sticky beak if I have some spare time :O

UAS have just installed a 2nd oil cooler to the GTR, and it looks like Im going to need it. The forecast is for 36 Deg tomorrow, so its going to be a stinker!!!!!!!

I will bring some beers!

post-42-1225331734_thumb.jpg

Fatz, you lazy bastted, have you managed to get me a spot yet?

Fatz and i and are actually at the moment a dual entry as i dont have a car for the track day. So technically there is 1 car spot available that the organiser do not know about.

However I was planning on taking my company car out for a one or two easy sessions - however i dont really want to use it.

Also i am more than likely end up picking up Fatz's spare shitter and use it on the day.




  • Similar Content

  • Latest Posts

    • Hell, I'm sufficiently wary of the ZSS suspension arms, let alone something like a hub.
    • Got it back home and got started pulling the hub off and diagnose the issue. Axle was stuck after removing the 36mm nut so i used a 3 jaw puller to try and push it out and... eH5FXvJ8.mp4   spend the next few hours trying to remove the axle from the remaining hub as it was very much jammed in there when the spindle sheared off. resulting damage as below R53AIy6 - Imgur.mp4   Looks like the was already a stress fracturing in the spindle as can be seen with the darker cracked section My working theory is maybe when the pinion gear exploded last year the shock put through the hub was the initial crack. Then a few events later it finally let go. Just lucky it happened where it did and not 190km/h on the next sweeper or into the hairpin The bearing/hub assembly went in in 2019 and were non-genuine "ZSS" assemblies and no nails were harmed in the process. #BreakHubsNotNails
    • Thanks mate, couldn't find in VIC, ended up ordering one from NSW, getting rwc to get new plates and registration done.
    • Before all the EFR fan boys come in, have a look at: https://www.garrettmotion.com/racing-and-performance/performance-catalog/turbo/g-series-ii-g30-825-58mm/ It also comes in a T4 1.06 divided housing. I would dare say if you want response & also decent power, this thing would chop.   AND apologies, just re-read your post, you've already bought the turbo... whatever you do, make sure you stick with divided housing and proper twin scroll manifold.
    • People have got to stop doing that. ShatGPT is not a search engine. It is a hallucination factory.   I also would recommend the 1.05. The .83 will "work" for you , in that it will be more responsive, but I think you'll find that it won't be anywhere near as good running it out to 8000rpm as the big housing will be.
×
×
  • Create New...