Jump to content
SAU Community

Recommended Posts

start by lifting an edge, remove the stripe by pulling it back on itself, go slow be careful or you may get chips of paint coming off with the stripe, you can try heating it a little whilst removing to help release the glue, after its removed give it a polish where the decal was. I've done it a few times usually very good success, a hairdryer for heating works well...

yeh that's how we did it when i was a spray painter only problem is its very brittle and you cant get very good continous pulls, i can put the time and effort into doing it that way with the heat but i was wondering if anyone had used and liquid products to aid them

There is a tool called an eraser wheel that you can buy, it attaches to a drill and helps get off vinyl that has been stuck on for long periods of time and has become brittle, it removes the vinyl without damaging the paint, and as said above, polishing up afterwards, or just a scrub with some metho should clear up any left over glue

so i got stuck into the stickers yesterday...heat and perserverance is all i could come up with being the stickers are so brittle it takes forever and as soon as you start getting a good run with taking the sticker off it breaks lol but owell ill get there and it will all be worth it in the end

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The issue now is the 'fuel cut' while driving, and when it happend, it does not stall. This, I did not test the fuel pressure while driving as I cannot with a fuel pressure gauge. I do have Nistune logs, yes. I have also replaced the MAF Sensor.   Also related to the FPG Fuel Hanger – I just realized that I need a Deutsch Crimp Tool to crimp some cables for the FPG Fuel Hanger. Need to purchase additional cables as the kit only included 2, which are for the float. FPG is has not responded to my emails so far after purchasing. I thought about taking it to someone and having it done professionally, but I am reluctant since everyone I took it to messed up in some way.  
    • There's a good German place in Brisbane if youre up for the drive 😛
    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
    • I would say no, why, because my daughter, who also lives in Goulburn, hasn't recommended us going there Pity, as we miss all the German joints around in Sydney, actually, the restaurants are the only thing I really miss about Sydney, and a special mention to Ishibanboshi at Bondi Junction, their Kara-age Don is heart cloggingly deliciousness (always added a special boiled egg...or 2) 😋 
×
×
  • Create New...