Jump to content
SAU Community

Recommended Posts

hey all, just curious if i could get some rough prices on spraying a full bodykit, and for spraying a whole car (r33) im still deciding whether i should spray just the kit as im getting a new one, or spraying the whole thing.

if someone could give me some rough prices on both, or some websites for workshops in vic that i can browse that would be great

PS ive tried searching, but no luck.

peace

Link to comment
https://www.sau.com.au/forums/topic/242059-spraying-price/
Share on other sites

  • Replies 58
  • Created
  • Last Reply

Top Posters In This Topic

the one at the top of this thread dosent have any websites, i dont really have time during the week to visit all the workshops :)

yes it would be definatly better if i spray the whole car at the same time, but more expencive ;) my current paint job bar a few things here and there is pretty decent. so yea

Link to comment
https://www.sau.com.au/forums/topic/242059-spraying-price/#findComment-4222350
Share on other sites

i checked the sticky, only DT panels didn't have a #, everyone else did.

depending where you are, if you're on a budget, DT Panels or Primal Garage (don't have personal experience) - one is east, one is west.

seriously, search harder... panel beaters/spray jobs/body kits, etc... those threads pop up with regularity in the Vic section.

Link to comment
https://www.sau.com.au/forums/topic/242059-spraying-price/#findComment-4223240
Share on other sites

... 800-1500 for a full respray + kit. I know some places thats all they charge... but you pay for good work. I'll just say that much.

Micolour will be substantially more than that, but then the work is without fault.

Also where is the kit coming from?

If its a copy kit... A lot of the time it isn't going to fit. There will be work required to make it fit correctly.

Hell even transit can warp body kits etc. So its highly likely.

Id' budget 3k at the bare minimum. If it was my car, i'd be budgeting 5k.

As ive said before... any spray can look good. Its 5-10years later that the really good work shines when the cheaper jobs fail due to poorer materials, prep and so on associated with low cost.

Oh, and most places dont have websites... its hard to quote anything online without seeing the car. Always best to take it for a visual.

Cheers

Link to comment
https://www.sau.com.au/forums/topic/242059-spraying-price/#findComment-4224056
Share on other sites

ok, kool thanks guys

and whats ur oppinion on spraying the whole car as apposed to just the kit? i can fix the parts of the car that are damaged easy enough, i just dont want to do the whole car if i dont need to...

Link to comment
https://www.sau.com.au/forums/topic/242059-spraying-price/#findComment-4224179
Share on other sites

i checked the sticky, only DT panels didn't have a #, everyone else did.

depending where you are, if you're on a budget, DT Panels or Primal Garage (don't have personal experience) - one is east, one is west.

From the two shops you mentioned, i would recommend DT Panels and not the other one.

Some panel shops create an orange peel effect on your panel. This shows the quality of the work. Experience from many people showed that we shouldn't be too anal about the cost, it is the effort put into the spray painting.

Link to comment
https://www.sau.com.au/forums/topic/242059-spraying-price/#findComment-4224721
Share on other sites

lol yea im not going to swap my house for a paint job on my car, if, IF the paint starts to look dodgy after 5 years, ill get another paint job, it will still be under 5k or 10k$

it might look dodgy but maybe i should just get the panels that have the damage on them sprayed? im just afraid the colour will be to different, i mean, the origional paint on the car hasnt faded bugger all, so perhaps im in the good!

PS its not a show car, its my everyday car, there will be stone chips etc, so im not gonna be extremely anal about it, aslong as its a decent job with no paint variations or bodgy paint spraying...

Link to comment
https://www.sau.com.au/forums/topic/242059-spraying-price/#findComment-4224810
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Before starting any work, we attempted to adjust the tune. However even after adjusting it to certain extremes like completely stopping fuel, it had no effect. What fixed it was removing the Nistune Board and installing the original EPROM instead. This immediately fixed the issue. Everything should have been fine with the Nistune Board installation, so I am unsure why it has caused a problem. The soldered connector is also properly soldered. This worked when I first got the 550cc injectors, before cleaning, but that may have been a coincidence.  We ended up not installing the fuel pump hanger (at least for now). So currently running stock injectors, stock fuel pump, stock fuel pump hanger – Well everything stock except the exhaust. Now I have around €1400 in Nistune, Injectors, and Hanger collecting dust for the time being, perhaps I'll install them in the future. For now I'll enjoy the car as is 😁 Thanks a lot for all your assistance, I really appreciate all the help you have given me.
    • The turbo can’t be the issue. They’re proven to make much much power than you’re making. There is something in the setup that isn’t correct. - has the exhaust got any silly step downs? - what exhaust manifold?
    • Ok, just the way you wrote it made it look like you had the stagger the wrong way around 
    • I was getting anxious with the DVLA not knowing if the paperwork is fine or not, so I rang them. No update had been given, but I  was reassured that providing the box was ticked on the V750 then the application will go through fine. I've been checking the DVLA website pretty much every day, in the hope that it would have been done. Fast forward to Monday 29th  and I was greeted with a new screen on the check, and it finally showed as Taxed and MOT'd, woohoo! The car was in desperate need of a clean, not knowing when this day was coming it was put off. As far as I was concerned I had another 3 weeks  I'm not normally one for using snow foam, but I wanted to give it another try It hasn't cleaned up too bad considering it's 21 years old and lived on a boat for a number of weeks. The personalised number plate is J2 XBK, an illegally spaced number plate would have it read J2X BK. BK could either represent  the colour black or Baker, which is my surname. I filmed the first drive, the Youtube link will be at the end. I used the same driving route I did with the 323F V6 when I had a new exhaust installed, heres a couple of photos A few more since then Youtube video can be viewed here: https://www.youtube.com/watch?v=TjkFHPzjGDw
×
×
  • Create New...