Jump to content
SAU Community

Recommended Posts

I have a premium coupe with Bose sound system as usual. Lately when going around corners the left speakers are dropping out. Now over some bumps the sound goes in and out. At first I thought it was just a loose speaker wire in the left hand door, but I have since realised the Left rear side speaker is doing the same thing, which I am guessing may have something to do with where the speaker wire plugs into the back of the stereo itself.

Just wondering if anyone has any suggestions before I start pulling the dashboard to bits?

Link to comment
https://www.sau.com.au/forums/topic/244823-bose-speaker-problem/
Share on other sites

two things there. the lock is a different probelm and a BITCH to change. about $300 for a new one ex japan.

the audio issue. look at the amplifer in the rear left corner of the boot. pull that out and down then look for dry joints. the radio does this as well but I have yet to see it.

the audio issue. look at the amplifer in the rear left corner of the boot. pull that out and down then look for dry joints. the radio does this as well but I have yet to see it.

Thanks for that Chris. I'll have a look at that. Now what is a "dry" joint?

Thanks for that Chris. I'll have a look at that. Now what is a "dry" joint?

If my year 10 electronics serves me correctly I believe it is something to do with fouled solder/contact points on the circuit board, either from wear and tear or from the factory

If my year 10 electronics serves me correctly I believe it is something to do with fouled solder/contact points on the circuit board, either from wear and tear or from the factory

or components that have worked loose due to vibration. considering how that amplifier is mounted I would point the problem there.

Dry joint, you need to re-heat the solder up and make sure it has continuity all the way through the joint.

If you are a bit unsure any good electrical component repair shop could do it fairly easily... or Chris I would think.

no probs. I'm between cars now (have another sedan due inthe morn) I'll take one of these amps out and take a few snaps of it for you.

if you do head down to see me - ring first.I'm not always here.

no probs. I'm between cars now (have another sedan due inthe morn) I'll take one of these amps out and take a few snaps of it for you.

if you do head down to see me - ring first.I'm not always here.

Yeah thanks.

I had a look at it this arvo, sure is a lot of wires going into the amp. Pulled out the plugs and had a look around, couldn't see anything obvious, but as a result of pulling it apart, I think the speakers down the left hand side are now sounding very ordinary (very little grunt) compared to the right hand side.

If I may make a suggestion before you rip the car apart looking for amps and shit, test something first.

When you're getting the problem while listening to a CD, flick over to the radio and see if it happens there (or any other audio source aside from the CD player if you have one). I get the feeling the problem is isolated to the CD player.

The 350Z Bose stereos have a known issue (with TSB I'm pretty sure, although I don't have it to hand) where the speakers intermittently drop out while playing CDs. It doesn't happen with the tape deck or tuner (or aux input for those cagey enough to figure out there was one), and it feels like a loose connection since hard accelerating/braking can start/stop the problem. US guys have complained about it, as have a few Australians I know. Since the Z and V share so many components, it could be a common theme.

Nissan Aus didn't even bother fixing it when 2 of my mates had the issue with their Z's. The head unit was replaced. Mine did it just after warranty expired. At first it was the passenger side (both front and rear). Then the driver's side occasionally. Then both. Then back to passenger side. I ended up using a FM tuner or tape to line-in converter with my iPod. I replaced it with a double DIN, and kept the amps and speakers stock, and haven't had issues since.

Edited by scathing
If I may make a suggestion before you rip the car apart looking for amps and shit, test something first.

When you're getting the problem while listening to a CD, flick over to the radio and see if it happens there (or any other audio source aside from the CD player if you have one). I get the feeling the problem is isolated to the CD player.

The 350Z Bose stereos have a known issue (with TSB I'm pretty sure, although I don't have it to hand) where the speakers intermittently drop out while playing CDs. It doesn't happen with the tape deck or tuner (or aux input for those cagey enough to figure out there was one), and it feels like a loose connection since hard accelerating/braking can start/stop the problem. US guys have complained about it, as have a few Australians I know. Since the Z and V share so many components, it could be a common theme.

Nissan Aus didn't even bother fixing it when 2 of my mates had the issue with their Z's. The head unit was replaced. Mine did it just after warranty expired. At first it was the passenger side (both front and rear). Then the driver's side occasionally. Then both. Then back to passenger side. I ended up using a FM tuner or tape to line-in converter with my iPod. I replaced it with a double DIN, and kept the amps and speakers stock, and haven't had issues since.

I think that's the exact reason!! When I play CD's like I mentioned above, the left side starts to cut out. Hard braking/accelerating does help the problem. I have tried to switch between the CD player and Radio and have found that it does not happen when I have the radio on. Hopefully installing a Dvd player with mp3 will work? Since it will be using the Aux setting? How else would you fix it ?

How else would you fix it ?

I dropkicked the Bose CD player into the bin, and installed an Alpine IVA-W202E.

Using the aux input should be OK, as the other two sources on my head unit (radio, tape) worked fine and I used interfaces to get my iPod to work.

Could this mean a 'Class Action' against B%SE?

Could B%SE prefer to compensate you all if you advertised in the media that...

a whole raft of people (SAUers undercover) were going to be present at a particular destination (after halfway thru a SAU Cruise) to...

SHOOT DEFECTIVE B%SE CAR AUDIO EQUIPMENT WITH A SHOTGUN !!!!!!!!

Wouldn't they prefer to pay you guys out than to LET THE SHOTGUN GO OFF!!!!! AND THE PUBLICITY THAT WOULD GET!!!!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...