Jump to content
SAU Community

Recommended Posts

+1 about trucks coming down the Mac Pass, especially when they do a left-hander - taking up both sides of the road.

I took a group of Skylines (from the Blue Mtns) + 1X NSX to Mac Pass early '07 and some of us do the Pass every 10 weeks (and old Pac Hwy every 6 months or so). We set off from Penrtih in the dark and got to the base at dawn.

There's 180 apexes from the base to the Robertson Pie shop.

Patrolling is only occasionally done at the top of the Pass for the last 4Km.

It's best to wait at the base of the Pass for >2 mins with no traffic going by and then start off up the hill. The only intersection on the way up to the top is a track off to the left that heads towards a canyoning site. At the top, there's a sharp righthander with virtually no traffic there except for a possible cop in wait.

During autumn, and after a wet night, one has to be careful about wet patches of road with leaves all over them. Stepping out is common in these sections.

Brilliant piece of hotmix tarmac. So good in fact that after refreshments at the Pie shop, you'll want to go down and then back up again.

If you have all day, this can be a suggested route...

i) Up Mac Pass > Robertson > left into Sheepwash Rd > left into Nowra Rd

ii) Down Cambewarra Mtn Rd > Bombaderry and then turn left > 1st speed camera as you arrive at Berry and then left into

iii) Kangaroo Valley Rd > right into Kangaroo Valley > Robertson and turn right at the Pie shop into

iv) Jamberoo Mtn Rd > turn left into Swamp Rd > Albion Park Rail > Princes Hwy

i)-iv) are all testing of you and your car.

Beware of occasional driveways on iii) & iv)

Two sections of overtaking lanes are available halfway up the Mac Pass and also near the top.

The lower section consists of sharp bends/undulations (which Old Pac lacks)/twisties and the top section has sweepers.

ENJOY !!!

Tez

+1 about trucks coming down the Mac Pass, especially when they do a left-hander - taking up both sides of the road.

I took a group of Skylines (from the Blue Mtns) + 1X NSX to Mac Pass early '07 and some of us do the Pass every 10 weeks (and old Pac Hwy every 6 months or so). We set off from Penrtih in the dark and got to the base at dawn.

There's 180 apexes from the base to the Robertson Pie shop.

Patrolling is only occasionally done at the top of the Pass for the last 4Km.

It's best to wait at the base of the Pass for >2 mins with no traffic going by and then start off up the hill. The only intersection on the way up to the top is a track off to the left that heads towards a canyoning site. At the top, there's a sharp righthander with virtually no traffic there except for a possible cop in wait.

During autumn, and after a wet night, one has to be careful about wet patches of road with leaves all over them. Stepping out is common in these sections.

Brilliant piece of hotmix tarmac. So good in fact that after refreshments at the Pie shop, you'll want to go down and then back up again.

If you have all day, this can be a suggested route...

i) Up Mac Pass > Robertson > left into Sheepwash Rd > left into Nowra Rd

ii) Down Cambewarra Mtn Rd > Bombaderry and then turn left > 1st speed camera as you arrive at Berry and then left into

iii) Kangaroo Valley Rd > right into Kangaroo Valley > Robertson and turn right at the Pie shop into

iv) Jamberoo Mtn Rd > turn left into Swamp Rd > Albion Park Rail > Princes Hwy

i)-iv) are all testing of you and your car.

Beware of occasional driveways on iii) & iv)

Two sections of overtaking lanes are available halfway up the Mac Pass and also near the top.

The lower section consists of sharp bends/undulations (which Old Pac lacks)/twisties and the top section has sweepers.

ENJOY !!!

Tez

Well written mate :D

The one thing Terry has left out.

Mac Pass: If travelling it over late Autumn/Winter/Early spring, be VERY VERY VERY careful of black ice. f**k being worried about the wet leaves. The black ice WILL take you out.

If travelling these areas of a night, or around dawn/dusk, be VERY careful of Wombats... I've nearly written a car off up there trying to dodge a Wombat that would have definitely killed me. Also, be very careful of Kangaroos.

If you decide to go up near Mt Keira, the warning used to be of a late afternoon or in the night be ware of the deer, but it's now a matter of what ever time of day it is, be ware of deer (I nearly took one out up there around 2 weeks at 1PM...) A friend lives just at the bottom of the start of the "no house" area of Mt Keira, and they constantly have deer around there...

Also, there's a few corners on Mt Keira, that look nice and good on camber left handers that dip down, and as you hit the apex dip back up (And make for excellent cornering speed) be EXTREMELY careful of these, as they are often VERY slippery as water sits here, and moss builds. The 3rd corner before the turn off to the first look out (Coming from the bottom) is very bad for this... I know quite a few people who've come off bikes on this corner, and I have spun into the cliff face myself writing a car off... Be very careful!

If you don't know either of these two roads, do NOT hammer up them the first time, take a scenic driver, there are some massive bumps that throw you in/out of the corners quite violently that if you don't know how to take, often land you in a tree, cliff, or oncoming traffic. Especially the one on Mt Keira just past I think it's the Scout Camp...

mac pass is good fun just careful of the trucks and buses,

robinson pie shop at the top is awesome, could eat them all day.....

Tristian you fool, Robbo pie shop is actually terribly shit. Especially compared to Alb Pk Rail pie shop, OR compared to the REAL Robertson Pie shop.

Any one who thinks those pies are good, has never had a decent pie!

The one thing Terry has left out.

Mac Pass: If travelling it over late Autumn/Winter/Early spring, be VERY VERY VERY careful of black ice. f**k being worried about the wet leaves. The black ice WILL take you out.

If travelling these areas of a night, or around dawn/dusk, be VERY careful of Wombats... I've nearly written a car off up there trying to dodge a Wombat that would have definitely killed me. Also, be very careful of Kangaroos.

If you decide to go up near Mt Keira, the warning used to be of a late afternoon or in the night be ware of the deer, but it's now a matter of what ever time of day it is, be ware of deer (I nearly took one out up there around 2 weeks at 1PM...) A friend lives just at the bottom of the start of the "no house" area of Mt Keira, and they constantly have deer around there...

Also, there's a few corners on Mt Keira, that look nice and good on camber left handers that dip down, and as you hit the apex dip back up (And make for excellent cornering speed) be EXTREMELY careful of these, as they are often VERY slippery as water sits here, and moss builds. The 3rd corner before the turn off to the first look out (Coming from the bottom) is very bad for this... I know quite a few people who've come off bikes on this corner, and I have spun into the cliff face myself writing a car off... Be very careful!

If you don't know either of these two roads, do NOT hammer up them the first time, take a scenic driver, there are some massive bumps that throw you in/out of the corners quite violently that if you don't know how to take, often land you in a tree, cliff, or oncoming traffic. Especially the one on Mt Keira just past I think it's the Scout Camp...

Tristian you fool, Robbo pie shop is actually terribly shit. Especially compared to Alb Pk Rail pie shop, OR compared to the REAL Robertson Pie shop.

Any one who thinks those pies are good, has never had a decent pie!

Where's the "REAL" Robertson pie shop?

I've had pies from the one at the top of Maq Pass and thought they were pretty good.

Threads like this are going to turn macpass into the next oldpac - eg, full of HWP waiting for imports.

You've found the road you're after, please let this thread die and go back a few pages - i doubt the police would read back that far. Oh yeah, if you dont think the police read our forums you're quite wrong ;)

I dont see the issue steve, if everyone drove to the road rules, no dramas!

anyhoo - speaking of pies....robertson pie ship or pie in the sky ? which is better? ;)

The minority wreck it for the majority Chris :P

  • 2 months later...

i just read bits and pieces.. are you saying the road with twisties after austinmere is maq pass???

its wat we call the national park run.

maq pass is well away from austi last time i checked.

Edited by Luke_GTS-T

Macquarie pass - goes up to Robertson / Moss Vale or Jambaroo Pass...

If you go up Macquarie pass follow that road all the way out along Robertson Road, Youll eventually come to a left hand turn which takes you to Nowra or Fitzroy Falls, there's two seperate mountains there will some pretty scrazy hair pin corners...

But beware its wet, ive lived in the area my whole life there is sooo many undercover cars around there now.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Here is the mess that I made. That filler there was successful in filling dents in that area. But in the middle area. I can feel dents. And I've gone ocer it multiple times with filler. And the filler is no longer there because i accidently sanded it away. I've chased my tail on this job but this is something else lol. So I'm gonna attempt filler one more time and if it doesn't work I'll just high fill primer the door and see where the issues are because guidecoat is of no use atm.
    • Ok, so I think I sort of figured out where I went wrong. So I definitely overthinked it, and I over sanded, which is probably a large part of the problem. to fix it, I ended up tapping some spots that were likely to be high, made them low, filled them in, and I tackled small sections at a time, and it feels a lot better.    I think what confused me as well is you have the bare metal, and some spots darker and some are lighter, and when I run my finger across it, it' would feel like it's a low spot, but I think it's just a transition in different texture from metal to body filler.    When your finger's sliding on the body filler, and crosses over to the bare metal, going back and forth, it feels like it's a low spot. So I kept putting filler there and sanding, but I think it was just a transition in texture, nothing to do with the low or high spot. But the panel's feels a lot better, and I'm just going to end up priming it, and then I'll block it after with guide coat.   Ended up wasting just about all of my filler on this damn door lol  
    • -10 is plenty for running to an oil cooler. When you look at oil feeds, like power steering feeds, they're much smaller, and then just a larger hose size to move volume in less pressure. No need for -12. Even on the race cars, like Duncans, and endurance cars, most of them are all running -10 and everything works perfectly fine, temps are under control, and there's no restrictions.
    • Update: O2 sensor in my downpipe turned out to be faulty when I plugged in to the Haltech software. Was getting a "open circuit" warning. Tons of carbon buildup on it, probably from when I was running rich for a while before getting it corrected. Replaced with new unit and test drove again. The shuffle still happens, albeit far less now. I am not able to replicate it as reliably and it no longer happens at the same RPM levels as before. The only time I was able to hear it was in 5th going uphill and another time in 5th where there was no noticeable incline but applying more throttle first sped it up and then cleared it. Then once in 4th when I slightly lifted the throttle going over a bump but cleared right after. My understanding is that with the O2 sensor out, the ECU relies entirely on the MAP tune and isn't able to make its small adjustments based on the sensors reading. All in all, a big improvement, though not the silver bullet. Will try validating the actuators are set up correctly, and potentially setting up shop time to tune the boost controller on closed loop rather than the open loop it is set to now. Think if it's set up on closed loop to take the O2 reading, that should deal with these last bits. Will try to update again as I go. 
    • More so GReddy oil relocation kits, sandwich plates, etc. all use 10AN fittings. And same, I've only used 10AN and my car sees track work (circuit, doing laps, not 10 sec squirt business).
×
×
  • Create New...