Jump to content
SAU Community

Group Buy : Motul 300v 10w40 (victoria Only)


Recommended Posts

MOTUL 300V 10w40 $89 for 4 L rrp $109 i will need about 15 people for this to go ahead no money up front will be needed

just leave your name if your 100% interested at the end of it i will get stock sent to

STATUS TUNING

63 Rodeo Drive

South Dandenong

Phone: (03) 9792 3333

Fax: (03) 9792 5555

E-Mail: [email protected]

OPEN 9.30am - 6.30pm Monday to Friday

(victoria) and can be paided and picked up from there

i will leave this up for 1 month from the 27/01/09 - 27/02/09

stock is coming from link international in Queensland

cheers

300V CHRONO

10W40

New 300V series is racing lubricant for racing cars.

MOTUL has developed “Double Ester Technology” for new 300V series, superior to complex ester that recognized the best base oil for engine oil up to now. Double Ester Technology, made by carefully balancing the ratio of complex ester and the newly developed macromolecular high polymer ester, enable base oil more wide-ranged, and delivers high output performance and superior reliability.

Also by carefully selecting the right polymer, “0% shear loss*” can be achieved.

*Diesel Injector method (CEC L-14-A-93), a standardized testing procedure for a lubricant’s shearing force.

Can be mixed with another viscosity of same series to achieve most suitable viscosity for the engine. (except for 5W-40)

* All-round use, designed for handling stable oil pressure preservation and sharp response.

* Compatible with a wide selection of engines — naturally aspirated, high torque turbo and cars that produce average to high levels of exhaust fumes.

SPECIFICATIONS

Product 300V CHRONO

Feature 100% Synthetic, Double Ester Technology, 0% Shear loss, can mix, for cars only.

SAE/DOT Standard 10W40

Specification Exceeds all existing standards

Maker's Approval —

Compatibility For a wide selection of engines — naturally aspirated, high torque turbo and cars that produce average to high levels of exhaust fumes

post-6642-1232982378_thumb.jpg

Why is it that motul dont make any of the 300V in 5L's? I asked the link rep last time he was up in our store and he didn't really know. Is there a reason for it? Always wondered about this.

  • 3 weeks later...
  • 2 weeks later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • I would agree.  There will be an amount of boost you could run safely with an otherwise factory system, but it would be low enough to not be worth the cost.  And if you are reliving your 20s, you know a 'little bit' was never enough. Personally, if I didn't want to spend the money, then stick with NA bolt-ons, and maybe a tune.
    • Fuark, at least the motor survived. What brand was the fitting that snapped?
    • Wrong question. There's no point in spending the rather large sum of cash and effort to add turbo, without taking it to the "sensible" limit of the motor itself. If you have to upgrade injectors, etc, then so be it. That is a tiny fraction of what it will cost you to turbo it.
    • Measure voltage at the starter solenoid terminal when the key is at start and it has clicked. If it is really low, then the suspicion falls on the ignition switch (contacts or wiring thereof) as causing a voltage drop instead of sending enough volts to throw the solenoid all the way to engage the starter itself. If it is a decent voltage, then the suspicion is on the solenoid. Might have s horted coil, or might hva dirty contacts. Rip the starter off, dismantle, clean up contacts and inspect winding. It might not be possible to see if there is a short in the winding though. I have a spare starter here that I could measure the resistance of the coil, as a guide to about what it should be, if you need a comparison. <parts hoarder>No you cannot have it.</parts hoarder>
    • lights are on just the one click.  
×
×
  • Create New...