Jump to content
SAU Community

Recommended Posts

  • 3 weeks later...

Hey Blitz

I'd be after the Tomei dumps if available still and brand new...$ ???

Also Brand New Carbon Fibre N1 Front Bar Vents - R33 GTR

and Brand New 400R Clear Front Bar Indicators - R33 GTR

Can you send me pm if still available, have the cash!!

cheers

Edited by elrodeo666
Hey Blitz

I'd be after the Tomei dumps if available still and brand new...$ ???

Also Brand New Carbon Fibre N1 Front Bar Vents - R33 GTR

and Brand New 400R Clear Front Bar Indicators - R33 GTR

Can you send me pm if still available, have the cash!!

cheers

Pm on its way mate, all 3 are still available.

Cheers.

Bloke do you want to sell this stuff or not.

An answer to pm's would be plain common decency!

I have coin waiting, let me know one way or the other please!

  • 5 months later...
Hi all,

Its time for another garage cleanout and as usual I have a stack of parts laying around that are going to waste and must go.

1. FET Power Direct Coil Packs (Model Number FPC-001)

post-46-1233275617_thumb.jpg

FET Power Direct Coils are a high quality Japanese made replacement upgraded coil pack for Nissan RB engines, and are essentially the same as those produced by Splitfire as a drop in replacement. The only real difference is the colour of the coils themselves, in that FET coils are red, and Splitfires are blue. These are in excellent condition and are great value considering the current price of a new set of Splitfires!

Please note these are NOT cheap Chinese coil packs

These coils use the same vehicle compatibility designation as Splitfire, and being 001's they will suit the following:

- R32 GTS-T (RB20)

- R32 GTR (RB26)

- R33 GTS-T (Series 1 RB25 only)

- R33 GTR

I am asking $390.00 Firm

2. Genuine R34 GTR Factory Injectors - Excellent Condition

post-46-1233275621_thumb.jpg

I have one set of excellent condition R34 GTR RB26 Factory Injectors that have only travelled 20,000 Km's

Perfect upgrade for an RB20, or a cheap and reliable replacement for old and busted R32 or R33 GTR injectors.

I am asking $360.00 Firm

3. Brand New 400R Clear Front Bar Indicators - R33 GTR

post-46-1233275630_thumb.jpg

This is a brand new set of Clear 400R Type Front Bar Indicators to suit Skyline R33 GTR that I purchased from Japan some time ago. I ended up with 2 sets so I had no need for these ones.

They are a direct fit replacement for the factory amber lenses and are a great aesthetic enhancement for any R33 GTR!

I am asking $185.00 Firm

4. Brand New Carbon Fibre N1 Front Bar Vents - R33 GTR

post-46-1233275637_thumb.jpg

I have this Brand New set of Carbon Fibre N1 Front Bar Ducts that I ordered from Japan for my R33 GTR and never got around to fitting. These are very very well made and look awesome when fitted, especially if you are chasing the full on JDM look :cool: I paid a packet for these but given they are just sitting on my shelf looking pretty its time to let them go.

I am asking $175.00 Firm

5. Used Factory ECU - Nissan Skyline R33 GTR

post-46-1233275335_thumb.jpg

This is the factory ECU out of my R33 GTR that was replaced by my Apexi Power FC.

These are very very handy and worthwhile holding on, especially as a backup in case you are defected.

I have no use for this so its just sitting around and like the other bits its time to go.

6. Brand New Tomei Engine Cover Ornament - RB26DETT

post-46-1233275546_thumb.jpg

Brand New Genuine Tomei Coil Cover Emblem/Badge for RB26.

This was to be fitted to a new set of painted engine covers I had ready to go on but it never quite made it on to the car.

I am asking $165.00 Firm

7. Used Factory Coil Pack Loom & Ignition Module - R32 GTS-T/R33 GTS-T Series 1

post-46-1233275611_thumb.jpg

I had this on hand as a spare. I never ended up needing it and it is now of no use to me.

I am asking $150.00 Firm for both items

All parts located in North Sydney - Happy to post at the buyers expense.

Come and get it :down:

Cheers.

do you have these vents still?

  • 5 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...