Jump to content
SAU Community

>>>> WARNING - GT Cruise Starts @ 9AM - CHANGE OF MEETING TIME >>>>


Recommended Posts

The meeting time @ School Rd for the GT cruise is now 9am. Leave around 9:30.

Please reply to this and give your acknowledgement.

Ill pm people who dont reply, or ring them if i know them.

Should make for a better drive.

Don't forget to suck the booze.

Hey Belgarion are you still organising the Gold Coast contingent??

And if so when/where are we going to meet before cruising to School Road??

Been hanging for a good mountain cruise for ages :rolleyes:

ok from memory it takes about an hour or more to get to school road, after i do my plugs and shit on the car, ill test it out, so im thinkin bp coomera. ill give a time that will allow everyone to get fuel, have sex in the toilets and take a agb

im guessin around 7:30 gives us plenty of time to get up to school road by 9am

Ok cool.

Will meet at the BP Coomera at 7.00am for a 7.30am leave.

Cruise or fast run?

I am down for either :burnout:

but would prefer just a cruise with a bit of boost everynow and again.

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
×
×
  • Create New...