Jump to content
SAU Community

Recommended Posts

I know the GT-R isnt a 1/4 mile queen BUT - those following the launch control saga with the Nissan R35 may know that USA spec cars have had their launch control reprogrammed this week such that a) you CAN use launch control with VDC on and b) it will only launch at about 3000rpm now (vs 4800rpm or thereabouts before).

The expected results : it would blunt the performance right?

however it seems some guy has just set another stocker R35 record with the software update today.

http://www.gtrblog.com/index.php/200...-quarte?blog=4

11.34@120mph is pretty amazing given this is a 100% stock car.

I'm guessing the update involved a tad more than changing the launch rpm...

progress.gif

LSX-438....

The new launch control ran a 1.69 60ft on the Dunlops, its good, but not as quick as the 1.44 60ft generated on the old Launch Control ;)

Feeding in the clutches at 3000rpm with the traction control working isnt going to be as fast as sidestepping the pedal at 4500rpm which is what the old LC system did. Not many of these guys understood that unless they made the car 'hook' that axle tramp would destroy first gear....now its been made 'soft' there will be no such problems :)

LSX-438....

The new launch control ran a 1.69 60ft on the Dunlops, its good, but not as quick as the 1.44 60ft generated on the old Launch Control :)

Feeding in the clutches at 3000rpm with the traction control working isnt going to be as fast as sidestepping the pedal at 4500rpm which is what the old LC system did. Not many of these guys understood that unless they made the car 'hook' that axle tramp would destroy first gear....now its been made 'soft' there will be no such problems :)

hence my surprise Martin!

- especially at the 11.3 "stocker record"

personally i think it's quick enough, albeit with a 3000rpm launch.

Edited by LSX-438
hence my surprise Martin!

- especially at the 11.3 "stocker record"

personally i think it's quick enough, albeit with a 3000rpm launch.

Whats more surprising is the 11.6 from that same car 'dead stock' with no Launch Control at all :D

When I refer to 'hook' its hook-up off the line....

Edited by Martin Donnon
Whats more surprising is the 11.6 from that same car 'dead stock' with no Launch Control at all :D

When I refer to 'hook' its hook-up off the line....

well that's true there could be something "special" going on with that car. Then again it's 3/10ths better from what we all expected (their prior results) - i think everyone just assumes it was going to be slower with the update, and yet it wasnt. I suppose we'll see a few others go out there soon and see what's what.

More results in...

Edmunds Update Their Long Term GT-R and Get Faster

Edmunds long term test blog has been debating on whether or not to update their Nissan GT-R with the latest software update from Nissan for a couple of weeks now.

They finally decided to go ahead with it (for science!) and have now put it to the test. They’ve confirmed what others are saying and the GT-R is only improved by this update.

Results - VDC Off:

* 0-60mph - 3.6 sec (3.3 adjusted)

* 0-400m ET - 11.6 sec @ 118.9 mph

Results - VDC On:

* 0-60mph - 3.6 sec (3.4 adjusted)

* 0-400m ET - 11.7 sec @ 118.5 mph

Their “tips” on launching the updated GT-R may explain why their time is not as fast as we’ve seen. Some owners are reporting that there’s more to it than just planting the brake and the throttle. There’s a certain technique and timing required to get the best out of the new launch.

They also don’t mention what transmission mode they’re in since you can now do it in manual and auto in any transmission mode.

Check out the link below for the full article with details and a comparison to their previous best results…

Link: Edmunds Blog: 2009 Nissan GT-R: Reprogrammed, Our GT-R Gets Quicker

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...