Jump to content
SAU Community

Recommended Posts

well im pretty pissed of today as i was reversing out of my garage (how unlucky is this) my garage decided it would be a good idea to just fold and come crashing down right onto of my skyline...as my car was in reverse it kept going so scratching it deeply from the end of the roof (near rear window) all the way til it hit my sunroof which was in a tilted position and that wedged itself into one of the groove of the garage and pretty much ripped out one of the rails...might i add this is an electric roller door, so then i stopped the car jumped out put the garage on manual, and drove my car foward to release it from my sunroof then it just went stright onto my roof and wedged my car inbetween..i was like f**k couldnt move it as it was out of the rails luckily my mate had rang me whom was around the cornor, came over and helped me get my car out, finally did that and the grabbed my neighbour whom is a handyman and he helped fix my garage so now its pretty much ok bit bent but ok...but my car omg the roof is just scratched to shit, im just so cut after you get it running mechanically fine something like that happens pure bad luck so that just tops of the rest of my shitty ass week.....any one have any idea what i would be looking at to get the roof resprayed?

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/
Share on other sites

oh f**k , my dad had that happen but not to that extreme, he was backing out and sat on the remote to the roller door.

landed on the boot, lucky he had these thick rubber strips on the door, and the door realised there was a car there and went back up.

seen in XXX bodykits window on Cheltenham road Keysborough. '$750 respray any car' .. somthing like that

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/#findComment-4435516
Share on other sites

damn that sucks man. almost happened to me the day i got my R34. mate sat on the remote and garage started to close car was half way in but trailer was behind me. good thing car was running so had to boot it out.

thats just unlucky though. hope it hasnt taken paint of that it will start to rust.

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/#findComment-4435583
Share on other sites

at the momet its looks ok...dont think any paint came off..but a couple of deep scratches which are roof length long rest is scrapage....its just i couldnt beleive how it happened, i cant even explain normally my garage would just go back up but didnt do that so i guess it buckeld

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/#findComment-4435594
Share on other sites

do you have house insurance? a friend had some gear stolen out of his wifes car and the house insurance covered it due to the car being on the property when the stuff was stolen. excess may be cheaper then paying for it outta your own pocket.

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/#findComment-4436484
Share on other sites

do you have house insurance? a friend had some gear stolen out of his wifes car and the house insurance covered it due to the car being on the property when the stuff was stolen. excess may be cheaper then paying for it outta your own pocket.

Thats a good call Ron..

Coz just say my car was parked in your driveway and your tree fell on it

you Home insurance would cover it..

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/#findComment-4436511
Share on other sites

eh dont think house insurance will cover it...cuz my old man said someone reversed into..dunno why, but if i say it came down onto my roof how could i possibly prove it wasnt my fault like i didnt accidently hit the button you know

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/#findComment-4437281
Share on other sites

^^^^ Doesn't matter dude, your insurance will still cover it, well if your insurance company is a good one it will. Exact same thing happened to a mate of mine in Taylors hill the other week, High wind screwed his garage (panel roller) and he didn't know. Opened door up started to drive out and the thing let go and crashed onto his car! His house insurance covered it.

Can't hurt to call them to see

Link to comment
https://www.sau.com.au/forums/topic/257823-fcuking-garage/#findComment-4437335
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...