Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

yer those camera's stand out pretty easy.

The song "theres a hole in my bucket" come to mind when i have pulled my car apart. Got the drivers side cleaned up and ready for metal to be cut out and new stuff welded in, passengers side is worse. This will take all week

yer those camera's stand out pretty easy.

The song "theres a hole in my bucket" come to mind when i have pulled my car apart. Got the drivers side cleaned up and ready for metal to be cut out and new stuff welded in, passengers side is worse. This will take all week

is it an expensive exercise ?

Hahaha no thanks

Anyone have ideas for how to make a pressure tester for my piping?

I'm thinking PVC end cap, drill small hole in side, insert bike tyre air screw part, seal around the edges and hook up to compressor.

Replace AFM with this item and listen for leaks in piping??

Will PVC withstand 10psi?

It will work, i have one that I run off my compressor. Just be careful not to over boost it though.

Less likely with a pushbike pump thaan a compressor but meh!

  • Nope 1

Please note that A J Wyllie Bridge on Gympie Road, Petrie is currently closed to traffic in both directions. An alternative route is available via Youngs Crossing Road, Petrie.

Advice has been received from Main Roads that the lower bridge may be opened late this afternoon. This will carry one lane of traffic in each direction. They have also provided advice that the high (southbound) bridge will be closed for some weeks due to extensive damage.

Weeks! FFFFFFFFFFFFFFUUUUUUUUUUUUUUUUUUUUUUUU

Time to find an alternative route to work...

It will work, i have one that I run off my compressor. Just be careful not to over boost it though.

Less likely with a pushbike pump thaan a compressor but meh!

Hahahahaha sweet... Yeah haven't decided if I'll use compressor or bike pump yet.

How did you block off the throttle? I only want to pressurise from air intake -> intake plenum (but not including the plenum)

Hahahahaha sweet... Yeah haven't decided if I'll use compressor or bike pump yet.

How did you block off the throttle? I only want to pressurise from air intake -> intake plenum (but not including the plenum)

I didnt block off the throttle.I just fit my pipe at the air intake then pressurise the whole system. Just rotate your engine till you find the sopt that holds pressure and pump away willis.

  • Nope 1

I didnt block off the throttle.I just fit my pipe at the air intake then pressurise the whole system. Just rotate your engine till you find the sopt that holds pressure and pump away willis.

Uhhh........ please explain this? :)

Drivers side is almost finished, welding in shorts and singlet is fun, except for when you get sparks and burn a couple little holes in your arm. Hopefully will have the passengers side started tomorrow so i can get the car running again before thursday night

So it seems that big thick sound proofing/ heatsheild mat that sits on the fire wall doesn't like to be welded or to be near welding. Just had a minor fire

Hey Noel, you wouldn't have any RB25 upgrade injectors you want to get rid of would ya?

i lost track earlier, what turbs did you end up going with?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



×
×
  • Create New...