Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Here are some pics of the prep and painting of a bumper for TwoCents. When Joel dropped it off it looked pretty good, but there were a few imperfections that would have shown up with paint.

IMG00144-20110903-1705.jpg

IMG00134-20110902-2235.jpg

IMG00133-20110902-2151.jpg

It also needed some reshaping.

IMG00138-20110903-0046.jpg

All repair work finished, bar primered and final rub down. ready for pait.

IMG00145-20110904-2059.jpg

Final finish.

IMG00148-20110904-2156.jpg

More pics can be found here Joel's bumper

Its birthday time of the year this year... now and november

F*cking 31 wouldn't start this morning. Piece of sh*t.

F*ck knows what's wrong with it...

didn't it do that last month too?

Morning Mangs,

F*cking 31 wouldn't start this morning. Piece of sh*t.

F*ck knows what's wrong with it...

shoulda bought a R32 GTR.

Yeah bitch the boot is finally on the other foot! :P

shoulda bought a R32 GTR.

Yeah bitch the boot is finally on the other foot! :P

Wiring fault. All fixed now :D

If it was a 32R, it would have been a big end and I would have been right f**ked :P

I dont know how successful I will be

That's what she said.

Is it Colins birthday?

Didnt he just have one last year?

Agreed. I though Rangas were only entitled to 1 birthday every decade.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
×
×
  • Create New...