Jump to content
SAU Community

Recommended Posts

  • Replies 47
  • Created
  • Last Reply

Top Posters In This Topic

i was leadin once and missed a turn, so we had to turn around, this was just after we did mundering, so real sorry to anyone who was getting pissed at me

nah you did okay, thanks for the fun run. pity about the cops, but lucky he was a nice guy!

and you followed Rhys and I who were the only one's who followed the map :( thanx Rhys for driving my car I was too scared!! Haha

ahahahhahahahahahhahahahahhahahahahhahahahahhahahahhahahahrofllolahahahhahahahha

hahahhahahahharoflroflroflhahahahha

u got to be kidding me mel u wimped out u r no longer one of us lol

still lots of love babe :(

Was a good cruise, even if we left early (we were getting pretty bloody tired). Had a good time even though the stops were too short and everyone started leaving when we wanted to stay for a bit longer.

Agreed, seems there were too many accidents and silliness really. For a section of the community trying to show how we are different to how we are portrayed. This cruise seems to have shown the police that we are the hoons that we are made out to be.

You cant complain about being picked on then group up to speed and race on the streets, where at least 3 accidents occured.

ahahahhahahahahahhahahahahhahahahahhahahahahhahahahhahahahrofllolahahahhahahahha

hahahhahahahharoflroflroflhahahahha

u got to be kidding me mel u wimped out u r no longer one of us lol

still lots of love babe :D

pfft, I made you biatch lol jkz I failed :P I'm afraid of heights k

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...