Jump to content
SAU Community

Recommended Posts

as per topic i want to fix my camber at back as one of my tyres wears badly on inner side

car has coilovers and hicas lock bar that's about it for suspension moods

what do i need ...rear upper camber kit or what?

what brands to use?

i seen few on ebay quoting they are good quality , there's few on there ?

what about whiteline kits?

Edited by 08r3308
Link to comment
https://www.sau.com.au/forums/topic/263949-fixing-camber-at-rear/
Share on other sites

Wearing on only one side is odd - any thoughts on why its not both sides? Something damaged perhaps? What are your current alignment settings?

Usually when you lower the car you need to add adjustability, and the more you lower it the more adjustability you require.

If you're not lowered, just get an alignment.

If you are lowered, put the kit in first then get the alignment. For my low GTR i needed two kits, i guess they put one at each end of the upper control arm.

no crash history as per previous post had that checked out and ruled that one out, well one side is more than other but both wear out on inside

can this be due to original bushes worn out , i think last aliment they maxed out stock bushes so cant be adjusted more

mr kotter is that with bushes only?

car is lowered and tyres do last few months (6-7) until i start noticing wear

isc how do complete kits compare to bush only?

i know bushes don't have as much alignment as full kits , but in terms on noise etc

Hey mate honestly when u lower an 33 they all have camber!! so don't stress, Yes those kits help but not that much. You can just flip the tyre (wheels stays put and tyres rotate) so you get double the life.

I am really interest as to wat those kits cost, if anyone has but them in can you please post the price

I got the Bilsteins and caster and camber kits via SK's GB a while ago but I never had my camber after alignment given to me .. what's the best way to find out the current camber on front and back ?

According to SK I should have -1deg camber at the front and -0.5 at the back. My 34 is lowered about 2cm and is using stock springs with Bilsteins.

If I lower the car any further will it be impossible to have same camber without using an extra camber kit ?

i think people are getting confused by using kit as in a whole arm and by just replacing bushes

p1otr if isc kits do go to 3+-(i read on few sites they do) in camber this will solve my issue and the tyre wear will be cut by heaps , i know all lowered cars will have camber and on r33 it gets expensive when you replace 19/265/30 due to camber wear

the bushes do not give that much adjustment imo so deltaforce is you lower any further just get the kit and be on safe side and not worry about it anymore even if you decide to go lower after that you know that camber adjustment will always be there

but if its $159 per camber arm, that's $640 for 4 + $400-500 in labour right ?

by the way, how much should I expect to pay to get my wheel geometry measured? I just want to know what my current camber is to see if the whiteline bushes that I have actually do anything

I had one of the whiteline bushes completely disintegrate on the front left wheel in less than 6 months ..but it was replaced since.

Edited by Delta Force

$159 is for 2??? not sure have to check with isc , i will be getting only 2 in my case

group install ehe i don't think they would be hard to fit as i will be doing this myself and then just going to sus place to get it adjusted and wheel alignment done

mr kotter is that with bushes only?

Yeah bushes only.

I checked out the isc website - the arms he has are rose jointed, and AFAIK that means;

- excellent control

- increased NVH

- shorter life (ie years instead of decades you'd get with bushes, also there doesnt appear to be any dust covers which would help)

- illegal for street use

If you're concerned about rose joint life, use search - its been discussed here before.

If you're concerned about the legality ask Ryan directly to provide proof they're street legal - i could be wrong (and am interested to know for sure)

interesting mr kotter and a good post, i have seen that just jap also sells some with rose joints that have rubber protectors in place.

so lets say a rose joint would last 2-3 yrs of daily driving or are we talking less?

another option might be bushes like you said but i dont think that will fix up my camber that much.

so whiteline come with one or 2 bushes or camber?

these can be diy or they have to be pressed?

The whiteline rear camber bushes gives +/- 0.75 deg of adjustment which should be enough unless your car is real low.

With these bushes you replace the inside bush of the control arm on each side, If you need more adjustment you can buy another kit and relace the outer bushes. (which givea total of +/- 1.5 deg)

Dunno about DIY, you could have a go at cutting the old bushes out. From memory there is a metal collar in the bush. I just took my control arms to pedders and got them to remove the old one and press the new one in. Didn't cost much, $30 i think...

Yeah, I used whiteline. Part number is KCA347

SuperPro, Pedders and UAS make simllar bushes, so you don't have to use whiteline. Try shopping around for the best price.

Again, how much has your car been lowered? My car was 340mm wheel to guard (30mm lower than standard) at the rear and one camber kit got me from -1.5 to -0.5.

More than +/-0.75, but my old bushes were stuffed.

Btw, you replace the inner traction rod bushes on each side as well as th UCA's. So in total the kit comes with 4 bushes.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well, I can recommend the partial AV system translation CD I ordered from Car Audio Workshop in NZ. Whilst it didn't address the date issue, it has conveniently translated on-screen menu items into English, and now allows the GPS-received time to be offset in hours rather than minutes, so I can display Eastern Australian time accurately ( and bump it by another hour when daylight savings starts ).
    • Yuh, if it's 45°C outside, my car is driving in it.
    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
×
×
  • Create New...