Jump to content
SAU Community

Recommended Posts

I thought I had sold all my left over gear but a quick look though the shed showed it not to be.

Tein Springs - Unknown rates $50 set

R/H Tail light $30

R/H Mirror $30

R/H Sill panel brand new $80

R/H door with a few dings and motor, no glass $30

Rear bumper support/reo $80

Radiator $40 fit gtr and gtst

Rb26dett block with cradle. Small crack between 2 head bolt holes. Would be fine for a std or mild motor. Original bores and has been freshly decked $200 Only removed due to cracked piston ring land.

Set of gtr interior door and rear trim bits inc head lining $100 A few nicks and scrathes but not to bad.

G sensor $60

A couple chipped GTR ecu's $125 each to suit the usual lights mods

Blitz turbo timer $50

HKS VPC $300

Gtst wing $10

GTR petrol tank with hangers and filler. A small leak in the seam about 5 cm long. Might be able to fix it with a soldering iron. $30

R33 Gtst genuine Jun front bar $400 Not a cheap Aus copy

If you intend to mess me around please don't waste my time. I'm not an internet nerd so therefore don't get on the net every minute of the day so responses might take a couple days. Please don't send multiple pm's.

40 minutes south of city.

i have a 32 and 33 looking for parts for both, do you have r32 gtr bar reo or stock cooler if so how much ?

also could you tell me about these parts below please ?

Tein Springs - Unknown rates $50 set ( are they for gtst or gtr ? )

Radiator $40 fit gtr and gtst ( does it have the fan cover what condition is it in ? )

Set of gtr interior door and rear trim bits inc head lining $100 A few nicks and scrathes but not to bad. ( do you still have this if so and there in decent condition could a have a look very interest ? )

G sensor $60 ( is this a stock or aftermaket part no idea what it is or does could you tell me ? )

Blitz turbo timer $50 ( do you still have this item ? does it have the wires and instructions ? )

HKS VPC $300 ( what is this whats ? whats it do ? whats it for ? )

R33 Gtst genuine Jun front bar $400 Not a cheap Aus copy ( is it painted if so what colour do you have a picture of it ? )

thank you

Tein Springs - Unknown rates $50 set ( are they for gtst or gtr ? ) The springs came out of a gtr with tein HA's in it. Would also fit a gtst I guess as springs are very generic.

Radiator $40 fit gtr and gtst ( does it have the fan cover what condition is it in ? ) The radiator came out of a shell I had. No shroud and will refund money if it leaks.

Set of gtr interior door and rear trim bits inc head lining $100 A few nicks and scrathes but not to bad. ( do you still have this if so and there in decent condition could a have a look very interest ? ) There worth the money I'm asking as they are just taking up space in the shed which is pissing me off. If your after a set of show peices their not for you.

G sensor $60 ( is this a stock or aftermaket part no idea what it is or does could you tell me ? ) Its for the 4wd system in gtr's. factory unit.

Blitz turbo timer $50 ( do you still have this item ? does it have the wires and instructions ? ) It has the loom for a 32 and you don't need instructions to use turbo timers. Very simple.

HKS VPC $300 ( what is this whats ? whats it do ? whats it for ? ) The VPC gets rid of the need to uses afm's on a gtr. they were about $2k new. Deletes the inlet restrictions of afm's. Comes with loom, controller and pressure and temp sensors.

R33 Gtst genuine Jun front bar $400 Not a cheap Aus copy ( is it painted if so what colour do you have a picture of it ? ) The bar is in pearl white but would need to be painted as I have to fix a few small cracks. I'm very handy with fibreglass as I have restored many boats and car bodykits. See attached pics

thank you

post-1670-1238918782_thumb.jpg

post-1670-1238918800_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
    • Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
×
×
  • Create New...