Jump to content
SAU Community

Recommended Posts

FAST and Furious - Movie night - Tuesday 21/04/09

Hoyts Cinema's in Woden.

Timing will be 9:30pm. I was hoping for a 8pm~ish session but doesn't seem to be available any day. There is a 7:15pm session but I think this is too early(???).

Post if interested, I'm probably going regardless.

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

yeh I'll be at work too but its all good... I'll see it another time :)

I'm kinda looking forward to this movie!

(did I just say that out loud :(:rofl::( )

Nothin to do with Vin or even Paul parkin their boots....Huh! :w00t:

Meh, I can't stop anyone, it's a public cinema. I know Quakin is bringing a crap box :P.

I guess the only thing I want to avoid is attention.........

I can not edit my first post but I would suggest everyone arrives atleast 30mins before the movie (before 9pm), seeing it's the first tuesday since opening.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...