Jump to content
SAU Community

Recommended Posts

Some questions about this.

It's an amplifier, but it's accepting an amplified signal already, ie the speaker output from your headunit which will typically be 22W RMS, however the rear speakers are only rated for 8W RMS. I haven't looked at the front ones.

Does it just drive the rear speakers or does it drive the front ones too. If it's just driving the rears then is it perhaps a high pass filter and the rears are just tweeters with the fronts being full range?

If it is actually an amplifier and drives all 4 speakers is there any way to trick it into accepting a line-level input as this will allow me to simplify my Car PC install dramatically as I'll just need to glue my USB soundcard to the amplifier and make up some leads rather than do a full amp+speakers installation.

the box is the rear amp it drives only the rear speakers i removed mine and spliced and soldered the wires together because it stuffed up and i wasnt getting a signal to my rear speakers any more its useless most decks perform better than 80's junk any how

  • 3 weeks later...

ok... so i removed 2 boxes today... (car did have hicas / abs etc..)

are they both amplifiers?????

one is a small one about 8cm x 3cm taken from under parcel shelf on drivers side moreso

the other is about A5 size... taken from just off centre moreso toward passender side from under parcel shelf.

they both for stereo???????????????

ta

  • 3 weeks later...

i have 3 unidentified boxes lol,,,

huge on on the passenger side bigger than computer silver with 2 looks

another in the middle ( the amp i think )

and 1 on drivers side much smaller with just 1 loom to it ?

anyone know what these are yet ?

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...