Jump to content
SAU Community

Recommended Posts

There is a big fat loom that goes from side to side along the radiator support and at each end there is a smaller loom going to the headlamps and another smaller loom branches off that for the foglamps. If you trace back the wires going to the head lamp you should find a spare branch on the way to the inch thick (25mm) loom.

Link to comment
https://www.sau.com.au/forums/topic/272506-headlights/#findComment-4627062
Share on other sites

There is a plastic screw cap that holds in a rubber boot but i think they only have to come off to change the bulb. the twin wires from the loom end in a black plastic plug which looks as though it just plugs into the back of the bulb although i haven't been able to pull it out to check without removing at least the battery clamps if not the whole battery ( I don't have very nimble hands).

Link to comment
https://www.sau.com.au/forums/topic/272506-headlights/#findComment-4627080
Share on other sites

attachment=226152:DSC01990_edited.JPG] I haven't pulled the bulb out to verify that it is the same as oddy man's but as that is printed on top of the light unit it seems likely. In that case you don't really need the plug (shown in the middle of the rubber boot) but just get a couple of terminals (like the yellow ones in the photo and crimp or preferably solder them to the ends of your wires and then push them on to the connectors sticking out of the bulb (just visible in the photo to th right of the bolt head in the middle left hand side).

[sorry - don't seem to be able to edit out the unwanted pdf file at the bottom]

310506att_2_.pdf

post-49463-1243829180_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/272506-headlights/#findComment-4628825
Share on other sites

so do these lights come on using the fog light button or are they just part of the normal lights, any pics with them turned on?? sorry to be a pain,

so i take it-it wont matter wihich way round these 2 wires go,

Edited by fat-lad
Link to comment
https://www.sau.com.au/forums/topic/272506-headlights/#findComment-4629379
Share on other sites

No it shouldn't matter which way round the two wires go. When you turn the fog lights on the tail lights come on as well, but they are quite independent of the headlights. If the plug has been chopped off the fuse might have been pulled as well. Try turning the fog lights on and testing the wires with a meter or test light or just any old bulb (and/or have a look to see if the tail lights have come on - they are also independent of the ignition switch so you don't need the key on).

Link to comment
https://www.sau.com.au/forums/topic/272506-headlights/#findComment-4630036
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
    • Thanks for doing that Duncan! Makes you a good person in my books. We don't get kangaroos or wombats here. But we have bats and it's similar. AFAIK it's often the mums with a baby attached that get hit because they drop lower when starting from a tree. If you hit an animal, check on it. https://www.ifaw.org/au/resources/wildlife-rescue-app An app to get the closest wildlife rescue contact.
×
×
  • Create New...