Jump to content
SAU Community

Recommended Posts

i assume you're looking at how to get it off becuase it has the dome topped bolts holding it in? all you need to do is get a dremel with a thinnish cutting blade on it and cut a slot in the top of them so you can undo them with a screwdriver :D

Link to comment
https://www.sau.com.au/forums/topic/273015-advice-please/#findComment-4633978
Share on other sites

having pulled apart a few ( but not a stagea one ) i would say it has roll pins pushed into holes that dont go the whole way through . either put small screws in them and pull them out or drill holes (its only poos alloy ) and push them through .

Link to comment
https://www.sau.com.au/forums/topic/273015-advice-please/#findComment-4642111
Share on other sites

Well it just so happens that one of us is a locksmith :) You will notice that there is a plug/pin pressed into the side of the ignition housing... well what you need to do is drill beside that pin and using a sharp centre punch tap with a hammer and lever upwards on the pin at the same time.Doing it this way you will be able to reuse the hole and the pin as opposed to drilling the pin. Some of the nissan ignitions have multiple pins so you will need to use this method for each pin. When they are all removed the ignition cylinder will just slide out of the housing.

Link to comment
https://www.sau.com.au/forums/topic/273015-advice-please/#findComment-4642130
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...