Jump to content
SAU Community

Advice Please

JAV360

By JAV360,
in Four Door Family & Wagoneers

 Share

Recommended Posts

M I K E Mentor

M I K E

Posted
Posted

i assume you're looking at how to get it off becuase it has the dome topped bolts holding it in? all you need to do is get a dremel with a thinnish cutting blade on it and cut a slot in the top of them so you can undo them with a screwdriver :D

Link to comment
https://www.sau.com.au/forums/topic/273015-advice-please/#findComment-4633978
Share on other sites
lachlanw Veteran

lachlanw

Posted
Posted

having pulled apart a few ( but not a stagea one ) i would say it has roll pins pushed into holes that dont go the whole way through . either put small screws in them and pull them out or drill holes (its only poos alloy ) and push them through .

Link to comment
https://www.sau.com.au/forums/topic/273015-advice-please/#findComment-4642111
Share on other sites
STAGWAGN Enthusiast

STAGWAGN

Posted
Posted

Well it just so happens that one of us is a locksmith :) You will notice that there is a plug/pin pressed into the side of the ignition housing... well what you need to do is drill beside that pin and using a sharp centre punch tap with a hammer and lever upwards on the pin at the same time.Doing it this way you will be able to reuse the hole and the pin as opposed to drilling the pin. Some of the nissan ignitions have multiple pins so you will need to use this method for each pin. When they are all removed the ignition cylinder will just slide out of the housing.

Link to comment
https://www.sau.com.au/forums/topic/273015-advice-please/#findComment-4642130
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • ARB26
      S1 Autech 260RS Wiring Diagrams

      By ARB26 · Posted

      I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...