Jump to content
SAU Community

Recommended Posts

I think you would be more than lucky if there isnt ceramic dust inside the motor...

But anyway, you cant really tell @ idle. Obviously power/boost wont be the same... thats a given, but then why even attempt that and almost gaurantee a dead motor.

Just pull the dump off

well you have two turbos too worry about. but if it's stock then that seems reasonable. what give you the incline that they were damaged or were you just asking for future reference?

when it happens you will know about it. if you have the cash get some steel wheels put in there or upgrade. my 2c.

Symptoms are: no ability to make boost, and crappy running if you run the motor under the conditions in which it would have made boost. The working turbo will just push air backwards through the broken turbo's compressor, therefore no boost at the plenum. Idle and low throttle are fine as you are in vacuum.

just put some steal wheel turbos on a mates gtr he was on his way to adelaide and was all fine then went to over take a car and no boost, there was no bang clunk or anything just fell off. replaced turbos and checked comp and all good.

so they can let go at anytime you dont need to be giving it a hard time at all. we also never found the wheel thanks to a decat pipe.

From what i have gathered you dont have to be boosting hard thus creating massive heat and spinning the turbos at 1000000rpm for them to let go.

I guess with age, the more shaft play u get, if the exh wheel only scrapes or bites the housing this would be enough to send it flying out the back!?! That's why it's more common with the r32?!?

Its predominately heat, heat generated by shaft speed IMO.

Which is too much boost in the given application in simple terms.

eg. You are probably OK with 13-14psi for usual street duties

Circuit you wouldnt run anymore than 11-12psi... being extended laps is going to get a lot more heat in there

Hence its usually the rear turbo that lets go - hottest cyclinders are 5/6 in a stocker style setup.

Hence its usually the rear turbo that lets go - hottest cyclinders are 5/6 in a stocker style setup.

Why do 5/6 get hotter? Is that why ppl richen up 6? Or does 6 run a little leaner than the others so its just compensating?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...