Jump to content
SAU Community

Recommended Posts

Part: Bonnet made of fibreglass with hood locks and pins, ths is a new topic yes as the old thread cant be edited**

Location: Southiside Brisbane, Qld

Price: $350

Condition: Fair condition, no chips in the bonnet, pretty dam light weight.(very dirtyatm, didnt wash it)if your really interested come & have a look

Contact: 0432 741 088

Pics Attached: Yes

post-33509-1245043336_thumb.jpg

post-33509-1245043375_thumb.jpg

post-33509-1245043412_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/274792-fibreglass-bonnet/
Share on other sites

because everyone has different expectations and if i say good condition some people will think its like brand new, it is in good condition.

that is why i only say its in fair condition bud, so noone misunderstands.

offers?



  • Similar Content

  • Latest Posts

    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
    • I _think_ that one has a christmas tree or some other retainer spike into a hole in that panel under it. Come in under it with thin scredrivers and just pry it gently up. If you rip the ears off the retainer pin....so what? Just stick it back down after with a bit of race tape and carry on with life.
×
×
  • Create New...