Jump to content
SAU Community

Recommended Posts

eveyone is telling me to do up the engine first and leave my looks stock, but i dnt see the point since i have an R34 25GT N/A and on my P's.

I think i should use my money on making my car look nice and have a crazy sound unit inside :down:

What do u guys think?

Open to all opinions.

Edited by ONLYR34
Link to comment
https://www.sau.com.au/forums/topic/282269-do-up-interior-exterior-or-engine/
Share on other sites

  • Replies 50
  • Created
  • Last Reply

Top Posters In This Topic

Firstly im a P plater myself and the boys in blue will pull you over for driving a skyline as they think all of us are hoons, they will check out your engine and if it is modded, you will get defected. Best spending your money on handling such as better suspension, brakes, tyres etc.. which is what i done.

Depends what you're after. If you want little 16-17yr old girls throwing their g-strings at you get some good quality rims (not china) with a nice stereo, very few girls know anything mechanical and under the bonnet doesn't impress them. There's not much to do aesthically, the r34 looks nice in stock form imo, just needs to be dropped with some good wheels.

If you want the car to be more enjoyable to drive, mick2nv hit the nail on the head, get the hard turning quicker (ie suspension/tyres) and stopping harder (brakes/tyres). I wouldn't go the engine mod path yet, the bang for buck just isn't there. Get a good catback so it sounds nice but thats as far as i would go with it. Much better off to wait till the p's are over then bolting a turbo on the side and since you would have the suspension/brakes sorted it should be a good package.

Either way, just dont go out and bolt on 20in china wheels, dropped with cut springs and "ice it" with a $99 pioneer 12inch sub running off a boss audio amp with stock nissan speakers.

Edited by R34GTFOUR
Either way, just dont go out and bolt on 20in china wheels, dropped with cut springs and "ice it" with a $99 pioneer 12inch sub running off a boss audio amp with stock nissan speakers.

+1

All three, but not OTT. :down:

Engine wise its not worth pouring dollars into. Just intake/exhaust maybe - get the air/gases flowing through high flow panel/pod filter, extractors, high flow cat and catback if you're after a little bit more go.

Exterior stock does look fine. As said, rims, lowered and its fine. Go a kit if you want it to look a little tougher or differentiate it from the other 34's getting around.

Interior - leatherette seats (seen them in group buys on here that looked alright), gauges, or as you said, sound system. I guess if you have some big subs in the boot weighing it down, you'll have excuse for the slowness of our NA's :bunny:

haha yeh im getting a set off my friend, 4 speakers and 2subs, hope it sounds good and doesnt blow.

Yeh i kinda got an idea now, but say i wanna get a kit, mine a grey sedan r34 know any sales that would go good on it??

And how much is it too respray kits?

im a 18yr old p plater got a non turbo 33. 98 modle. what ive done is just suspention rims 9inch tyres so its sits well some sways and coilovers, all the handling stuff and i also got myself a custom exhurst and a set of extracters made up and hes working a treat, sounds and looks awesome :down:

goodluck

Do Up Interior, Exterior Or Engine?, what would u do if you are on your p's?

None of the above. I'd save up money so I can sell it and buy a fast car when I get off my P's. But that's just me. I like driving fast cars fast.

It depends on your priorities. If you don't care about how fast your car goes then, by all means, rice up the vehicle. I wouldn't throw money into a car I wasn't planning on keeping for a while.

If you don't mind going slow then stick with your 25GT. Do the suspension to clean up the handling a bit, and use your money get it to look and feel the way you want it to.

If you're planning on selling the car when you get off your P's then I wouldn't bother doing anything at all. It's money you won't be getting back and money you wouldn't be getting good value from.

I am a P plater aswell, own a 96' R33 GTS4. My car is mostly stock except the wheels, sound system and...an exhaust I have sitting here waiting to put on haha. Since we are very restricted on what we can do I believe it all comes down to what you want to do in the future. If your going to keep the car and wack in a turbo later then start off with the suspension and handling. I'm not planning to go through that phase but instead I am going on the saving route haha and hopefully can afford a GTR once I hit my full lisence. With that being said, you can always do things to your car and then take them out and put them into your new car.

Like I said, it all comes down to your plans on the future with the car, you don't want to spend a crap load of money in the end and expect to sell it in 2 or 3 years and get it all back, it will turn into dead money. So yes, first plan the cars future before starting to work on it :)

How much are your prepared to spend?

What are you looking for? Bling or Race spec?

Suspension is a must!

If not coilovers.. a good set of spring and shokies will go a long way!

A good seat if your going racing..

A light set of rims too.

All depends on how much your willing to spend..

i'm with everyone else, suspension and handling first, especially if you're planning to turbo the car later down the track.

get some:

decent adjustable coilovers/shocks and springs

wider lightweight rims + decent tyres

thicker sway bars

slotted rotors

decent pads

braided brake lines (or at least new lines)

Nah i'm not gonna turbo the car up later because, it still wont be as fast as the GTR.

so i'm probably just gonna leave it until i'm off my p's and just sell it

the thing i'm probably gonna do is the sound system and maybe a kit :/

thanks for all opinions :P

Nah i'm not gonna turbo the car up later because, it still wont be as fast as the GTR.

so i'm probably just gonna leave it until i'm off my p's and just sell it

the thing i'm probably gonna do is the sound system and maybe a kit :/

thanks for all opinions :P

best way to do it less mucking around and my be the cheaper alternative, i say do the basics to improve handling, looks and sound then save up for when you come off your p's and go turb's, revert your current car back to stock and put all the other things into the new car if you go a r34GTT that is! Good luck with it mate :laugh:

as long as its your way mate there's no right or wrong answers. Steer clear of engine mods while your on your p's to avoid defects, but also keep in mind if your selling later on what will make it sellable later on.

Ie do the basics like suspension, brakes, wheels, zorst. Stereo and kits are great but becareful you dont get too committed and throw bulk dollars at the temporary ride (eg keep it tame).

I've got a 34 N/A, had it for about a year and a half, and have a year n a half til I get off my P's, I've just done things I can take off when I sell it as I plan to a few weeks before I get off my P's to buy a GTT or 32R. If I get the GTT most things from my car will fit onto that, rims bodykit etc. and I've kept the stock ones to put back on when I sell it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...