Jump to content
SAU Community

Recommended Posts

front cross member $40

right hand rear tail lights x2 $50 each

rear steel rio $30 each

rear window $80

1/4 windows $40 each

clock spring $65

clutch master $70

clutch slave $70

alternator $70

series 2 white rear garnish $40

series 2 white boot lid $50

r33 rear cut $250

r33 front cut $250

brake master cyclinder non abs $70

abs s2 motor $100

roof linning $30

sunvisiors $30 pair

parcel shelf $40

rear parcel shelf speaker holders $30 pair

full set of seat belts $100 ono

s2 hicas rear rack $70

s1 & s2 steering rack $80

s1 & s2 front castors $60 pair

s1 & s2 rear axles $60 pair

rear r33 s1 and s2 calipers $120 pair

rear discs $50 pair good condition

front tanabee struts and springs $140 pair

right hand front lower control arm x 2 $40 each

r33 front damaged shell with compliance not listed as damaged anywhere $750 have front cut to fix

r33 jap fibreglass wing think its a trust copy $60

r33 s2 sideskirts have a crack on rhs one $80 pair

r33 a pillar plastics $50 pair

r33 interior plastics have all of them $offer

r33 series 1 rear quarter interior panels $40 pair

all items located in melbourne's northern suburbs

call 0402090079

lots of other bits avaliable just ask . dont have front end bits like lights motor bonnet guards front bar or front rio but have most of other parts required

Edited by SXC_R33
Link to comment
https://www.sau.com.au/forums/topic/283527-r33-gtst-s2-parts/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...