Jump to content
SAU Community

Recommended Posts

  • Replies 716
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

wellllllll

turns out you need wheels nuts to drive

jenna helped out and changed the tyres while i was working on the electricals.

long story short she didnt tighten one of the rims up

it decided to part company with the car about 500metres from our joint in spectacular fashion with about 50 metres of warning

took half the guard wore out half and inch of the rotor and ground down about half the tow hook

anyway could have been alot worse no one was hurt and we had it back and running with the nuts 30 minutes later

she wont do that again

final resting place

IMG00105-20110508-1342.jpg

ouch

IMG_9454.jpg

ouch 2

IMG_9455.jpg

lol3

IMG_9456.jpg

the dude in the range rover net to use had a bit of a shock when he was racing our rims doen the hill

after we fixed it some old f**ker tyred to flog the rim when i was picking it up

lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Not really, but the heater box is pretty simple mechanically....if the door is one way the air bypasses the heater core and if it is the other way it goes through it for warm air.  If you are sure the actuator you moved manually is for the heater mix (there would also be one for output air direction) then I'd take the heater box out and see what is happening (you'll have to regass and re-coolant the systems afterwards) BTW pp724 onwards from the GTR workshop manual cover the system in good detail, it is probably worth checking. I think the IAT sensor might be a problem electrically for getting cold (if you got 24 error code not -24 it thinks the incoming air is -50c) and it covers how to test the sensor (although most likely it is either not plugged in or a wire is damaged)
    • Use the GKTech subframe bush and bring your subframe 10mm closer to the chassis. You'll need to fix an exhaust hanger to suit. One of the best mods I've done.
    • You'd really have to pull it apart further to know, it least you can be confident that the one heading to the back is not connected any more. There was once a ground on the shifter seal mount too, your head unit issue could be that simple
    • Perfect, I'll get to it this winter then at the same time as I weld on my anti squat kit. 
    • Alright so my 32 only has one temperature no matter what degree you set it to. I’ve tried disconnecting the servo motor arm and moving it either direction and got no change. I’ve fixed the leak in my AC and re charged it and with it on and clutch engaged it still blows hot even though the low pressure pipe going to the firewall is ice cold. Both heater core hoses are hot while running as well. Diagnostic code showed 24 for intake air temperature sensor. Anybody got any ideas?
×
×
  • Create New...