Jump to content
SAU Community

Recommended Posts

Firstly check VIN # > History of where it was owned. If it came from anywhere on the north island of Hokkaido (ie names like Kushiro, Sapporo, Hakodate, Asahikawa, Muroran etc) the chances of rust are huge.

Where? As mad082 said^^^, and also struts, rails, door hinges, wheel well...

there is one more spot. dont forget to look around the boot brake light, it can get rust around there, mine has a little bit atm.

That is indeed the most common arear for rust. I've seen a lot of new imports with rust just below the brake lens, including my old GTT.

  • 3 months later...

It is very common - but not something to worry about because it's one area where the rust is quite visible; and thus, most people attend to it quickly.

After washing the car, you'll notice that water likes to sit beneath the lens; so it pays to soak it up.

After it's fixed, it won't tend to recur under Australian conditions because in Japan, where there's salt in coastal areas, salting of roads in Hokkaido, SO2 & SO3 gasses (emitted by lots of cars in crowded cities where many drivers don't drive very far) which mixed with moist air > H2SO4 (sulphuric acid).

It is very common - but not something to worry about because it's one area where the rust is quite visible; and thus, most people attend to it quickly.

After washing the car, you'll notice that water likes to sit beneath the lens; so it pays to soak it up.

After it's fixed, it won't tend to recur under Australian conditions because in Japan, where there's salt in coastal areas, salting of roads in Hokkaido, SO2 & SO3 gasses (emitted by lots of cars in crowded cities where many drivers don't drive very far) which mixed with moist air > H2SO4 (sulphuric acid).

Cheers Terry, thanks for the fast response and clarification! ;) Any other known potential rust trouble spots that should be checked apart from around the spoiler base and around the windows?

Thanks again mate!

Edited by KR4-GTR

The most common area I see from freshly imported cars into our workshop is the underbody. Mostly it's light surface rust from the salt used in snow regions which can be removed. But on some occassions I see quite substantial rust which obviously is a lot more difficult to remove.

Those salty roads are the pits.

Talking on Nissan 4x4 forum to a guy in Ireland who bought a low mileage 2nd hand Patrol but she's got an engine oil leak.

Turned out the sump has rusted through.

Piece of foam material between bellhousing and sump had absorbed the brine and rusted right through the sump.

Wondering about the rest of the underbody?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...