Jump to content
SAU Community

Recommended Posts

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

R30 for sure :) I almost vomit looking at R33's, The worst looking skyline ever made

considering every man and his dog has one you'l have to get some airsick bags for your back pocket when you go outside then

Have opted for a Chaser to replace my daily drive but i'm still a Nismo fan through and through but Chaser's do kick ass

Dave,

I like your choice of replacement, I was going to do similar with a JZX90 (is that correct) chaser, but good ones were hard to find so I went with a 1UZ conversion to my MX83 and now I think I have the best Toyota cruiser in the country.

January 08, I did Sydney to Melbourne via Hume, Great Ocean Rd ~ Torquay to Port Campbell and back up the coast through Lakes Entrance. Covered 3920k on 176L fuel which calculates to 9.6L/100k and has power / torque to burn.

Pity you can't keep both.

I did a bit of cruising on Yahoo Auctions last night and your sedan isn't bringing money in Japan either, found some with starting figures of AU$100.00 with no bidders, so it might be a store it for a while deal and wait out the crisis the world seems to be in at the moment.

Cheers, D

Dave,

I like your choice of replacement, I was going to do similar with a JZX90 (is that correct) chaser, but good ones were hard to find so I went with a 1UZ conversion to my MX83 and now I think I have the best Toyota cruiser in the country.

January 08, I did Sydney to Melbourne via Hume, Great Ocean Rd ~ Torquay to Port Campbell and back up the coast through Lakes Entrance. Covered 3920k on 176L fuel which calculates to 9.6L/100k and has power / torque to burn.

Pity you can't keep both.

I did a bit of cruising on Yahoo Auctions last night and your sedan isn't bringing money in Japan either, found some with starting figures of AU$100.00 with no bidders, so it might be a store it for a while deal and wait out the crisis the world seems to be in at the moment.

Cheers, D

hmmm well looks like i'll have to keep her then..

here are some picks of the new one. >

CIMG2355.jpg

CIMG2347.jpg

SilverChaser2.jpg

OK where do i get one... I want it!!!

sexy huh??

you like???

this thing flys and is still compfy as f&ck to cruise in..

landed with a few extra goodies we didn't know about at auction..

besides the $6.5k BBS rims and HKS suspension, a kick ass top dollar exhaust, nice recaro seat and Defi guages etc.... it's got a full OS giken gear set, twin plate brass buton clutch that is a dream to use believe it or not, and, a 1.5 way mech. diff!!!

who ever had the car in Jap. new their stuff and didn't like skimpin on the $$'s

OK where do i get one... I want it!!!

Ya gunna need lots & lots of bottle tops for one of these.

I much prefer the JZX90 shape to the 100 & later.

Only problem for me it can't tow my Skylines where the V8 does it eazy.

Cheers, D

Ya gunna need lots & lots of bottle tops for one of these.

I much prefer the JZX90 shape to the 100 & later.

Only problem for me it can't tow my Skylines where the V8 does it eazy.

Cheers, D

i reckon it would do the trick but i would stick with the 8 for the job.

the 1jzx has an awesomely torquey motor and the low down power is quite surprising... all about the VVTI now - nice smooth power band

so you actually have this landed and all??

pic dude!!!!

gee i wonder what randy would reckon

got the car on Friday and have put it through the it's paces... the thing flys! and the power comes on nice and smooth

I'll put some more pics up of that one soon

Randy, well i'll be dropping in there soon as all the good dyno tuners are out his way

  • 2 weeks later...

** Thread cleaned up**

Dennis, It doesnt hurt for him to try for a high price, and if you feel the need to tell someone they are asking to much, keep it to PM please.

There's no need for a keyboard war over someones asking price, no matter if you are the seller, or a prospective buyer(or just reading the thread)

Keep it to a dull roar people.

Cheers

Jason

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
    • So, what else.... Power. I don't know what it is making because I haven't done a post tune dyno run yet; I will when I get a chance. It was 240rwkw dead stock. Conclusion from the day....it does not need a single kw more until I sort some other stuff. It comes on so hard that I could hear the twin N1 turbos on the R32 crying, and I just can't use what it has around a tight track with the current setup. Brakes. They are perfect. Hit them hard all day and they never felt like having an issue; you can see in the video we were making ground on much lighter cars on better tyres under brakes. They are standard (red sport) calipers, standard size discs in DBA5000 2 piece, Winmax pads and Motul RBF600 fluid, all from Matty at Racebrakes Sydney. Keeping in mind the car is more powerful than my R32 and weighs 1780, he clearly knows his shit. Suspension. This is one of the first areas I need to change. It has electronically controlled dampers from factory, but everything is just way too soft for track work even on the hardest setting (it is nice when hustling on country roads though). In particular it rolls into oversteer mid corner and pitches too much under hard braking so it becomes unstable eg in the turn 1 kink I need to brake early, turn through the kink then brake again so I don't pirouette like an AE86. I need to get some decent shocks with matched springs and sway bars ASAP, even if it is just a v1 setup until I work out a proper race/rally setup later. Tyres. I am running Yoko A052 in 235/45/18 all round, because that was what I could get in approximately the right height on wheels I had in the shed (Rays/Nismo 18x8 off the old Leaf actually!). As track tyres they are pretty poor; I note GTSBoy recently posted a porker comparo video including them where they were about the same as AD09.....that is nothing like a top line track tyre. I'll start getting that sorted but realistically I should get proper sized wheels first (likely 9.5 +38 front and 11 +55 at the rear, so a custom order, and I can't rotate them like the R32), then work out what the best tyre option is. BTW on that, Targa Tas had gone to road tyres instead of semi slicks now so that is a whole other world of choices to sort. Diff. This is the other thing that urgently needs to be addressed. It left massive 1s out of the fish hook all day, even when I was trying not too (you can also hear it reving on the video, and see the RPM rising too fast compared to speed in the data). It has an open diff that Infiniti optimistically called a B-LSD for "Brake Limited Slip Diff". It does good straight line standing start 11s but it is woeful on the track. Nismo seem to make a 2 way for it.
×
×
  • Create New...