Jump to content
SAU Community

Recommended Posts

so yeah thinking of upgrading my turbo when i do my engine build, so here it is, vg30 single turbo BB, internal gate, never ran past 9 psi,

its off a 88 y31 cima.

looking for $400 ono

pm or sms 0450929227

Phone571.jpg

Ryan

Link to comment
https://www.sau.com.au/forums/topic/289221-fs-vg30-turbo/
Share on other sites

i have a high flow version of one of these on my 33, a lot of ppl like high flowing a 33 turbo with the rear housing off one of these, for a cheaper option one of these are a straight bolt on but have a thicker shaft so even with the ceramic rear wheel (which i still have) you can safely run 15psi, for a while i was running 18psi without a problem.

Dont know if the front wheels are any bigger than an rb25, any chance of getting you to pull the cover off and measure it, got a standard rb25 here that i can measure to compare.

Link to comment
https://www.sau.com.au/forums/topic/289221-fs-vg30-turbo/#findComment-4847445
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...