Jump to content
SAU Community

Recommended Posts

Car is now up for sale as whole, if someone is good enough it could be repaired. Car still remains the same as above posts, less rego, obviously roadworthy and rays wheels are no longer availible with car. I'm after $3800 with interior or $3000 without rear seats and front bucket seats would be replaced stock seats in the front. Will sell interior seperate for $800 if anyone is interested.

post-46575-1259668946_thumb.jpgpost-46575-1259668960_thumb.jpg

post-46575-1259668980_thumb.jpgpost-46575-1259668990_thumb.jpg

post-46575-1259669009_thumb.jpgpost-46575-1259669018_thumb.jpg

Edited by smallman

depends what you can do by your self, if you found a half cut with no engine and you can put the straight front end on your self. Would be a little bit of time and the cost of the half cut. Also you would have to get the chassis rails pulled out.

if the chassis rails are fked, it's as good as a write off. it ll never be the same again. the most profitable way would be to part out the car and fix the engine, if it has minor damage.

the chassis rails are not f**ked, they have minor damage but still need to be pulled out. My friend bent his rails on his 33 pretty bad and he managed to get them pulled out and there is nothing wrong with the car.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...