Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

i must say, coronas are pretty weak eh? i had 10, had to take it easy, my boy isnt so considerate

the morning after a big night and im trying to sleep. lol

made me feel kinda flat and not in the mood...slight headache this mornin, all good now.

back to rum next time me thinks..

winner

so hows everybody feeling? i know after 13 cans of johnnie red last night im not feeling too bad. different could be said for earlier on though, slept most of the day haha. biggest sitting ive had in a long time. was a great night but

plans for the weekend?

I just got this stuff for the stag http://www.invisionsales.com/headlight_restoration.html should stop them going foggy again.

I purchased the same kit yesterday on recommendation. Im going to do the job hopefully tomorrow, will post before and after pics when I am done.

i think i heard about that, some guy got pissed off with everyone asking him if he was selling e's or if he had e's and he finally got fed up with it so started a punch up with the next guy to ask him... thought it was a bit of a strange responce. =\

i think i heard about that, some guy got pissed off with everyone asking him if he was selling e's or if he had e's and he finally got fed up with it so started a punch up with the next guy to ask him... thought it was a bit of a strange responce. =\

thats the most rediculous explaination ever

-D

That shit is exactly why I bailed on town a while back, too many hardcunce. I spent NYE drinkin with a mate and playing a few games of pool, was a good night.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...