Jump to content
SAU Community

Recommended Posts

twas alright

at least i didnt hav to drive an AU falcon LOL

Shaddapa yo face!

Dropped off passenger just past marion, came back up marion road..and had a copper just flashing his lights to get through traffic, came speeding up about 100m behind me..and because the customers car has bald rear tyres..and i didnt have my P plates up...i'm fairly sure i shat my dacks. Luckily, he didnt notice, and flew past me.

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

I heard that the AU falcon nearly put ford out of business!

Stereo is crap, seats are horrible. Dont get me started on the Auto POS.

Has done 120,xxx kms, and has already reemed 2 diffs.

Did anyone else just see the article on a current affair?

Some guy carving up the streets in sydney driving a "nissan turbo" (was a s14), with aca telling everyone to look out and report him :banana:

I'm sure that will cause more bad rep for us all.

hahaha thats hilarious - not a bright spark filming himself doing that on public roads with his numberplates in full view - and ACA is just as dumb for asking the public about it when they've got the numberplates and can just turn it over to the Police... idiots.

hahaha thats hilarious - not a bright spark filming himself doing that on public roads with his numberplates in full view - and ACA is just as dumb for asking the public about it when they've got the numberplates and can just turn it over to the Police... idiots.

It's called sensationalism

Unless this guy is constantly on the run, Why don't they make a house call if they have his rego plates? Assuming they're A. not stolen plates B. plate swap and havn't changed the rego over?

they will find him.... if the rego plate fails to find him, im sure his own face will corner him! haha

some one out there will have a grudge against him and pass on his residential details..

i reckon his car will be confiscated as i type.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...