Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

what about rego'ing a defected vehicle that didnt even have time to be transfered into the new owners name??

dont know, never had to do that one before.

best to get the old owner, to get the manual rego form filled out, then the new owner can do the leg work to get it off defect and then transfer rego.

to find out if you can transfer rego on a defect car, go to regency rego office next to the VIS as they seem to be more knowledgable then the other rego offices.

in honour of everyones fav ns thread :down:

post-31501-1266203605_thumb.jpg

post-31501-1266203599_thumb.jpg

post-31501-1266203610_thumb.jpg

post-31501-1266203615_thumb.jpg

we need like an official record ruling about thread length and time cause i dont think ive ever seen a thread hit 50 pages that fast before.

Edited by Inline 6
in honour of everyones fav ns thread :down:

we need like an official record ruling about thread length and time cause i dont think ive ever seen a thread hit 50 pages that fast before.

thread posted - 05 February 2010 - 04:38 PM

first post on page 50 - Posted 12 February 2010 - 08:59 PM

and there has been 1544 replies :|

about 15 of those posts have been relevant lol

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Have you confirmed its the actual axles? Also the wheel bearings that mount on the hubs to hold the axles wear out. I replaced mine as they got play in them. It sorted my play issue. 
    • Ive converted a few clusters for the R33 with 320km/h dials. On the back there are some pads which can be bridged or unbridged (using solder or wick braid) to calibrate it. There is one bridge which is for MPH <> KPH; and there are combinations of bridges to offset it. There is probably a diagram  For example; this is my conversion for a 180km/h dial to a 320km/h dial (I put custom GT-R dials on it with the GTS25t layout) If you have J2 soldered (assuming the S clusters have a similar config to the R clusters); you may need to remove that solder
    • Back on topic 😉, these are some of the notable pages from the booklets that are supplied with each weekly parts update. I never knew the BNR32 test mule car had an S13 Silvia body...
    • This. A 3d wheel alignment is like $120...just take it to the shop. Since theres probably multiple adjustments that need to be made after changing something. Mine has front/rear lower arms, traction rods, tension rods, camber arms, toe arms, front upper arms, hicas kit, sway bars and coilovers. I measure from the edge of the bolt holes on the originals and set the same length on all the adjustable stuff to dial it as close as I could to OEM. Took it straight for alignment; it didnt feel right at all...after alignment, it feels perfect. Similarly i've just changed the springs on another car; and I still needed multiple adjustments to bring it back in spec.
    • A full Veilside kitted JZA80 Supra in Meriken park in Kobe city a few weeks back
×
×
  • Create New...