Jump to content
SAU Community

Recommended Posts

Just got back from Melbourne. Left Adelaide at 4:10Pm yesturday arrived in melb at 5:30ish melb time. Picked up a 280rwkw supra with a mate and drove it back.

First road trip. Wasn't to bad :happy:

I like the trip between Adelaide/Melbourne - its not too long.

It was epicly fun driving back in the GTR... and kind of not at the same time(stiff suspension and loud exhaust with windows down made the right ear feel a bit funny after awhile), and surprising not too bad on the wallet - less than 2 tanks of fuel.

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

i did adelaide to canbera in a stiff as coilover swift with no a/c in 40 degree heat. we were both burnt like lobsters on arrival. went through about 10 litres of water each.

but you gota look at it as an advernture :happy: and country people are funny when they see a modded car

Edited by Inline 6

On the weekend I drove to and from bendigo, VIC in an R33 with coilovers and 300~rwkw and only wet through roughly 4 tanks of fuel including driving around bendigo and heathcote,

I wasn't a problem at all.

SOO my horns dont work now

press the horn button and all i get is clicking in the engine bay from the relay

ive replaced all the fuses to no success

so this would indicate that the horn has been shorted out

correct me!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...