Jump to content
SAU Community

Recommended Posts

He guys my mate is selling his S14 Garret T-28 Turbo. Im interested to know if this is a good upgrade over the standard r33 turbo. The specs are below. Im planning to run 17psi out of this turbo if possible.

Turbo specs:

Compressor: T-28, 60 trim 60 mm BCI-1 compressor in T-04B housing

Turbine: T-25, 62 trim 53.8mm 0.64 A/R turbine housing.

Center Section: Ball Bearing

Cheers

ak

Link to comment
https://www.sau.com.au/forums/topic/29870-r33-with-s14-turbo/
Share on other sites

Simple answer. **** NO.

As MJ says, by the time you get everything altered to fit the turbo it'll cost too much to be worthwhile.

Don't forget the dump is different, oil and water lines different, exhaust flange is different, compressor outlet is different.......

And you'll make less power too.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
    • I _think_ that one has a christmas tree or some other retainer spike into a hole in that panel under it. Come in under it with thin scredrivers and just pry it gently up. If you rip the ears off the retainer pin....so what? Just stick it back down after with a bit of race tape and carry on with life.
×
×
  • Create New...