Jump to content
SAU Community

Recommended Posts

hi all

i have an r32 gtst and when i turn the key to start the engine the alarm goes off while it is cranking, butstops as soon as the key is released and the car does not start

it was working fine until i did the following

tryed removing the steering wheel that is on there (aftermarket one), no luck getting it off tho so i left it. might add that when i was trying to get it off the adjustable (kalaidascopic) steering column slipped a few times as the lever came down from all the shaking)

i then went and replaced the rocker cover gaskets, the only electrical items i touched were the ignition module,(the one at the back of the valley cover, removed and unplugged)

and the coilpack plugs,(unpllugged)

after putting all the engine bay back together i went to start the engine and its all normal untill it actually cranks and the alarm sounds and the engine doesnt start

the alarm is a cheetah alarm and the remote has 3 buttons, unlock lock annd an unknown one.

has anyone else had any problem like this before

just taking a stab here - have you tried resetting your car alarm? say if there is any override switch / earthing tab / etc - check your alarm manual/documentation (if you have it).

seen a very similar issue recently happen to a mates car when one of his battery terminals was loose and came off while driving; car shuts down - he checks battery, reconnects terminals, goes to re-start and take off, but the alarm constantly sounds and immobilises the engine from starting, no matter how many times he tried disarm the alarm with the remote control.

After a couple of hours messing around with it (and around 5 different mates coming past to try and work it out), finally read the alarm manual/documentation and read up on using the override function. Solved the problem

Do you have an alarm with battery backup? If you do, the 'start' process is draining the car's battery to the point that it cannot keep enough voltage to the alarm siren. The siren thinks the battery has been disconnected, and "goes off", using its own battery for power. When you stop cranking, external voltage is restored to the alarm siren, and it turns off.

The symptoms are coincidental. Did you have the stereo going while you were doing all this work on the car?

Try jump starting the car. But you may well need a new battery.

Do you have an alarm with battery backup? If you do, the 'start' process is draining the car's battery to the point that it cannot keep enough voltage to the alarm siren. The siren thinks the battery has been disconnected, and "goes off", using its own battery for power. When you stop cranking, external voltage is restored to the alarm siren, and it turns off.

The symptoms are coincidental. Did you have the stereo going while you were doing all this work on the car?

Try jump starting the car. But you may well need a new battery.

you may well be on the money, it is battery backup, and i did have the stereo cranking for a while but not the whole time.

i will try a jump start tonight

cheers for the replys guys

well got home after work and started it and it started first go, weird huh, id say it was wat blind_elk was saying about low battery, and overnight the battery had rejuvenated itself.

thanks all

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I mean, I can confirm the TPS is at 100%.... I can confirm when we installed the TB and setup the cable that the TB was indeed fully open at max pedal travel.. the same 'curve' (WRT MAP vs MAP) existed with the previous setup/TB/manifold as well... No, we did not do a run with no intake connected. I would love to go back in time to do such a run to rule out the intake. It would have also been good to do a run with the airbox lid off. There's a test there where increased IAT vs more available air could be a positive tradeoff. I remember taking the lid off my R34 Turbo setup back in the day and noticing a monster increase, even if IAT's did go up. Could be similar. Hard to test unless I find a very deserted road. 
    • That's actually encouraging to be honest. my motor was rebuild many years ago but it's probably done less than 30,000kms and fucc all limiter or drift, majority street / drag / roll racing. It'll be fine 💪🏼 I don't even have lines or a can for the cam breathers installed yet, there is zero oil residue or splatter on or around them, it drives beautifully so it seems healthy. Just a ticky lifter, yet they're almost brand new oem genuine Nissan and haven't done many kms at all...
    • Have you confirmed the throttle body goes to WOT (and stays there) during the run?
    • I'm having a problem. I think it was mentioned above somewhere but can't see it.  I'm stuck in the cycle of, sand, filler, low spot again, put filler, sand, low spot again, now i put filler again and a thicker portion which seems to have helped but I got low spots in other areas. In the image. Circled in red thats where the original low spot was and the shape is the same as the red out line. I've more or less fixed that (still low spot up the top but now I have low spots where the green circled part is.  Is likely the issue that I didn't start with a course sand paper? I sanded the filler with 240 to reduce the risk of not going to far but maybe the issue is that I'm only taking off enough material to remove some of the filler but not the high spots. I now started sanding with 120 and I think I'm seeing a difference. I did fix one dent the other 2 are f**ked and seems like I made another low spot which is indicated by the furthest green circle on the left handside. Any thoughts and solutions?   Also second image. All of these rock chips, can they be filled in with primer or do i need to fill them all with filler/putty? So many rock chips on mine lol.
    • Well, I had an Edward Lee's special edition odo windback car/motor with a RB25DET S2 and I put down 372kW with a good amount of track abuse for 1.5 years before the ring lands decided it didn't want to stick around anymore 🥲 But probably didn't help I kept on smashing try limiter on the track and a few skid pans.
×
×
  • Create New...