Jump to content
SAU Community

Recommended Posts

a year ago when i got mine they were 610 for the whole set, thats pick up as well... all depends on the jap aussie dollar at the time... id personally go with the mechanic ones lol

as ive posted so many topics in the last few days some of u may know i jus got my R34 converted to a manual since i got it back nothing but litle problems..

my newest problem is the check engine light will come on and the car's exhaus note will sound exactly like a wrx (like the putting and stuff like that) and the car starts to shake in low revs feels as if its gonne stall on me... annnd i can hav my foot flat to floor in any gear and it will jus go nowhere like i mean struggling to hit 50klms in built up areas...

it slips in and out of this mode but the engine light never goes off but sometimes it will jus randomly go back to normal sounding (the exhaust note) and suddenly my power will be all back.. then the exhaust will start putting and sounding like a classic rex and it will run like crap again :D

could it be because i still have the auto ecu running and never hooked up the manual ecu?? or does it just need a tune or in anyones opinion/experience is it something else??

cheers

coilpacks......i had the same problem..took it to a few places coz they thought it was the ecu....in the end i needed coilpacks.

ended up gettin splitfire ones, and works perfectly..not gauranteeing thats the problem but the symptoms sound very similar to a problem i had. take it to an autoelectrics place or sumthin like that

Maybe take it back to the workshop, I'm sure they could sus it out for you seeing the car was working fine before they touched it.

But yea from what it sounds like coilpacks, find one of your mates and swap, if it fixes, get some coilpacks:)

If NOT, go back to the workshop that did conversion.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I read this and thought "ah! I will do this scissor jack on the tow point thing!" I just use my floor/low profile/costco jack and lift the car up by the tow hook itself, then slide jack stands under. Never thought about using scissor into floor jack combo :p
    • Well, my new WMI system took much longer to finalize. I actually missed my dyno appointment last Friday and lost my 150$ deposit. I'll be going back in the next week or two.  To sum it up. I only kept the AEM tank from my old setup. I replaced the AEM pump with a higher flow/pressure ProMeth 30GPH pump. I also swapped over to a 6AN low pressure feed line to the pump from the tank. There's also a pressure switch you cannot see on the pump high pressure line.    This is feeding 6x 200CC direct port nozzles and 1x 500CC Pre Throttle body nozzle. All fittings are Swagelok, because well why not. I also have a 300PSI pressure sensor up front.    I now have my Haltech ECU controlling everything. I start my pump with a basic relay at 5PSI and deadhead it. I then PWM a 3000CC methanol Injector to control flow starting around 10psi. The pressure switch in the trunk, along with my tank level are safeties before I ever get to 10PSI, and then I use my pressure sensor upfront as a secondary safety to cut the WMI and corrections in case the injector blocks or a line ruptures.  Wish me luck on the dyno!    
    • So, I'm back with bad news. There's no jack long enough on this planet that will reach the front subframe. If by some chance there is, it would weigh 200lb's.  I purchased a long reach jack... The damn thing weighted 120lb's and was massive. Didn't even come close, was still short at least a foot. It was a pain, but I brought it back. Next I decided HA! No problem, I'll get an Extra long reach jack. Well, I couldn't lift the box... It must have weighed 160LB's and luckily there was an open box in store. I took measurement and was still nowhere close.  Sadly I've lost hope and have accepted defeat. 
    • Thanks for that tip, niZmO_Man. I think the battery is OK. It's quite a new one, but I'll check. Last time I needed a new battery, everything electronic was fine, except that there wasn't enough current to turn over the starter. I decided to order one of the partial AV system translation CDs from Car Audio Workshop in NZ. That might have some effect, or help me diagnose the date problem. 🤞
    • I suppose it was relatively stock too, the JZ motor handle most mods thrown at them without even breaking a sweat 
×
×
  • Create New...