Intercooler Question

[Hanso]

Hi,

I was checking out this intercooler that is for sale in the QLD Classifieds, link>> Intercooler sale

Would this match up with the stock intercooler holes in my Series 2 Stag? I'm guessing it would haave to be mounted behind the front bar, but I have a factory thermo fan there.

Any help would be appreciated.

[-RBD2-]

its easy enough to make fit,buy some angled silicon pipes if need be

maybe even have to cut one or both of the pipes and use joiners to get the right angles

good luck mate

[QWK32]

the factory thermo fan isn't really an issue, it does come close at the bottom but you should clear. the thing that really gets in the way is the stock auto cooler which you don't have to worry about judging by that picture though (it is hard to tell), but i'd say that pipework wont match up. the S2's stock pipework comes through right beside each other, it might not be an issue for you but you may have to open up the holes bigger to get them to align up.

your link doesn't work for me, what are the specs on the cooler? i'm using a 600 x 240 return flow. if i mount it any higher id have to chop out the top part of the rear as well, at the moment i have only trimmed the bottom section. and mounted any lower and the return pipe will hang out the bottom of my front bar.

[KiwiRS4T]

Hi,

I was checking out this intercooler that is for sale in the QLD Classifieds, link>> Intercooler sale

Would this match up with the stock intercooler holes in my Series 2 Stag? I'm guessing it would haave to be mounted behind the front bar, but I have a factory thermo fan there.

Any help would be appreciated.

Some people manage to miss the aircond fan altogether - others just cut bits off that stick out and reroute the power cable. In my case I have a replacement, thinner fan.

[chuckie]

I have one should be ok .

pipe work will be tight on stock bar but it`s a neet fit other wise ,

Don`t need to do much ,

Just mark & FOLD REO BAR there is some pic`s i put up before,

Cheer`s Chuckie .

[Hanso]

I have one should be ok .

pipe work will be tight on stock bar but it`s a neet fit other wise ,

Don`t need to do much ,

Just mark & FOLD REO BAR there is some pic`s i put up before,

Cheer`s Chuckie .

Cheers mate, I saw ur install in the intercooler thread.

I'll see how it goes over the weekend. I want to put it in before I drive to Albury-Wodonga next week.